Water hardness in Daniels County, MT

Water in Daniels County is very hard, with a median of 292 mg/L (17 grains per gallon) across 20 monitoring sites.

86% harder than the Montana median (157 mg/L) 24th hardest of 56 counties
292mg/L
17 grains per gallon
Very hard

Daniels County water at a glance

  • HardnessVery hard (292 mg/L, 17 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 292 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 17 gpg (16.4 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites20
Lab samples81
Sample years2000–2026
Middle 50% of sites258–350 mg/L
Groundwater (wells, springs)276 mg/L · 6 sites
Surface water (rivers, lakes)295 mg/L · 14 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Daniels County

Prefilled with Daniels County's measured local hardness of 292 mg/L (17.1 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Daniels County on the Montana map

Garfield CountyPowder River CountyFallon CountySweet Grass CountyLewis and Clark CountyRavalli CountyPetroleum CountyMeagher CountyBeaverhead CountyWheatland CountyCuster CountyFlathead CountyBlaine CountyHill CountyPowell CountyMineral CountySilver Bow CountyMadison CountyGranite CountyCarbon CountyLincoln CountyDawson CountyStillwater CountyMissoula CountyGallatin CountyJudith Basin CountyPrairie CountyTeton CountyBig Horn CountyGlacier CountyValley CountyPark CountyWibaux CountyJefferson CountyBroadwater CountySheridan CountyCarter CountyTreasure CountyYellowstone CountyPondera CountyPhillips CountyRosebud CountyToole CountyFergus CountyMcCone CountyLake CountyMusselshell CountyDeer Lodge CountyCascade CountyChouteau CountyGolden Valley CountySanders CountyRichland CountyLiberty CountyRoosevelt County

Cities and communities in Daniels County

PlaceMedian mg/LClassBased on
Scobey 295 Very hard 6 sites within 10 miles
Flaxville 292 Very hard county median
Peerless (CDP) 145 Hard 5 sites within 10 miles
Whitetail (CDP) 292 Very hard county median

Water quality in Daniels County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Scobey City of Scobey Not tested 0 lead · 3 unknown None
Flaxville Town of Flaxville Not tested 0 lead · 0 unknown 3

Neighboring counties

Montana

The statewide median is 157 mg/L (hard) from 4,906 sites.

Montana hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next