Water hardness in Washington County, OR
Water in Washington County is moderately hard, with a median of 68 mg/L (4 grains per gallon) across 28 monitoring sites.
Washington County water at a glance
- HardnessModerately hard (68 mg/L, 4 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 68 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 4 gpg (3.8 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Washington County
Prefilled with Washington County's measured local hardness of 68 mg/L (4 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Washington County on the Oregon map
Cities and communities in Washington County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Hillsboro | 60 | Soft | 11 sites within 10 miles |
| Beaverton | 67 | Moderately hard | 30 sites within 10 miles |
| Tigard | 60 | Moderately hard | 40 sites within 10 miles |
| Aloha (CDP) | 68 | Moderately hard | 25 sites within 10 miles |
| Tualatin | 61 | Moderately hard | 43 sites within 10 miles |
| Forest Grove | 41 | Soft | 6 sites within 10 miles |
| Wilsonville | 66 | Moderately hard | 53 sites within 10 miles |
| Bethany (CDP) | 28 | Soft | 13 sites within 10 miles |
| Sherwood | 64 | Moderately hard | 44 sites within 10 miles |
| Cornelius | 82 | Moderately hard | 11 sites within 10 miles |
| Cedar Mill (CDP) | 65 | Moderately hard | 21 sites within 10 miles |
| Oak Hills (CDP) | 37 | Soft | 15 sites within 10 miles |
| Rockcreek (CDP) | 48 | Soft | 12 sites within 10 miles |
| Bull Mountain (CDP) | 68 | Moderately hard | 31 sites within 10 miles |
| Cedar Hills (CDP) | 63 | Moderately hard | 28 sites within 10 miles |
| West Haven-Sylvan (CDP) | 67 | Moderately hard | 28 sites within 10 miles |
| Garden Home-Whitford (CDP) | 60 | Moderately hard | 32 sites within 10 miles |
| West Slope (CDP) | 65 | Moderately hard | 29 sites within 10 miles |
| Raleigh Hills (CDP) | 67 | Moderately hard | 30 sites within 10 miles |
| King City | 68 | Moderately hard | 35 sites within 10 miles |
| Metzger (CDP) | 59 | Soft | 41 sites within 10 miles |
| North Plains | 88 | Moderately hard | 8 sites within 10 miles |
| Durham | 57 | Soft | 40 sites within 10 miles |
| Banks | 19 | Soft | 5 sites within 10 miles |
| Gaston | 33 | Soft | 7 sites within 10 miles |
| Rivergrove | 57 | Soft | 44 sites within 10 miles |
| Cherry Grove (CDP) | 31 | Soft | 9 sites within 10 miles |
| Dilley (CDP) | 45 | Soft | 9 sites within 10 miles |
| Marlene Village (CDP) | 63 | Moderately hard | 28 sites within 10 miles |
Water quality in Washington County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Hillsboro | City of Hillsboro | None detected | 0 lead · 0 unknown | None |
| Beaverton | City of Beaverton | None detected | 0 lead · 0 unknown | None |
| Tigard | City of Tigard | None detected | 0 lead · 0 unknown | None |
| Tualatin | City of Tualatin | None detected | 0 lead · 0 unknown | None |
| Forest Grove | City of Forest Grove | None detected | 0 lead · 0 unknown | None |
| Wilsonville | City of Wilsonville | None detected | 0 lead · 0 unknown | None |
| Sherwood | City of Sherwood | 2 found | 0 lead · 222 unknown | None |
| Cornelius | City of Cornelius | None detected | 0 lead · 0 unknown | None |
| West Slope | West Slope Water District | None detected | 0 lead · 0 unknown | 1 |
| North Plains | North Plains Water Department | Not tested | 0 lead · 2 unknown | None |
| Banks | Banks Water Department | Not tested | 0 lead · 0 unknown | 1 |
| Gaston | City of Gaston | Not tested | 0 lead · 2 unknown | None |
| Rivergrove | Rivergrove Water District | None detected | 0 lead · 0 unknown | None |
Neighboring counties
- Yamhill County96 mg/L
- Columbia County24 mg/L
- Tillamook County25 mg/L
- Multnomah County39 mg/L
- Clatsop County21 mg/L
- Polk County38 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.