Water hardness in Yamhill County, OR
Water in Yamhill County is moderately hard, with a median of 96 mg/L (5.6 grains per gallon) across 44 monitoring sites.
Yamhill County water at a glance
- HardnessModerately hard (96 mg/L, 5.6 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 96 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 5.6 gpg (5.4 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Yamhill County
Prefilled with Yamhill County's measured local hardness of 96 mg/L (5.6 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Yamhill County on the Oregon map
Cities and communities in Yamhill County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| McMinnville | 122 | Hard | 33 sites within 10 miles |
| Newberg | 99 | Moderately hard | 27 sites within 10 miles |
| Sheridan | 139 | Hard | 15 sites within 10 miles |
| Lafayette | 123 | Hard | 40 sites within 10 miles |
| Dundee | 116 | Moderately hard | 31 sites within 10 miles |
| Dayton | 125 | Hard | 39 sites within 10 miles |
| Carlton | 67 | Moderately hard | 20 sites within 10 miles |
| Amity | 126 | Hard | 34 sites within 10 miles |
| Yamhill | 44 | Soft | 17 sites within 10 miles |
Water quality in Yamhill County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| McMinnville | Mcminnville Water & Light | None detected | 0 lead · 0 unknown | None |
| Newberg | City of Newberg | None detected | 0 lead · 0 unknown | None |
| Sheridan | City of Sheridan | None detected | 0 lead · 0 unknown | None |
| Lafayette | City of Lafayette | None detected | 0 lead · 7 unknown | 3 |
| Dundee | City of Dundee | 1 found (PFOA ND / PFOS 5.4 ppt) | 0 lead · 0 unknown | 1 |
| Dayton | City of Dayton | Not tested | 0 lead · 491 unknown | 1 |
| Carlton | City of Carlton | Not tested | 0 lead · 82 unknown | 1 |
| Amity | City of Amity | Not tested | 0 lead · 0 unknown | 3 |
| Yamhill | City of Yamhill | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Washington County68 mg/L
- Polk County38 mg/L
- Tillamook County25 mg/L
- Marion County44 mg/L
- Multnomah County39 mg/L
- Columbia County24 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.