Water hardness in Cedar Mill, OR

Water in Cedar Mill is moderately hard, with a median of 65 mg/L (3.8 grains per gallon) across 21 monitoring sites within 10 miles.

about the same as the Oregon median (71 mg/L) 31st hardest of 67 Oregon towns Population 14,546 (2010)
65mg/L
3.8 grains per gallon
Moderately hard

Cedar Mill tap water at a glance

  • HardnessModerately hard (65 mg/L, 3.8 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 65 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 3.8 gpg (3.6 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites21
Lab samples966
Sample years2000–2025
Middle 50% of sites28–85 mg/L
Groundwater (wells, springs)225 mg/L · 1 sites
Surface water (rivers, lakes)56 mg/L · 20 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Cedar Mill

Prefilled with Cedar Mill's measured local hardness of 65 mg/L (3.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Cedar Mill tap water

Cedar Mill is served by more than one water system. These systems supply ZIP codes in Cedar Mill and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Cedar Mill

Water systemPFAS detectedHighest PFOA / PFOSTested
Portland Water Bureau
serves over 10,000 people
None detected — Feb 2024 – Nov 2024
Tualatin Valley Water District
serves over 10,000 people
None detected — Jul 2023 – May 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Cedar Mill

Cedar Mill is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Cedar Mill

Water systemService linesTotal
Portland Water Bureau0 lead · 0 galvanized · 0 unknown189,613
Tualatin Valley Water District0 lead · 0 galvanized · 0 unknown62,067

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Cedar Mill drinking water violations

Cedar Mill is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Cedar Mill

Water systemHealth-based violationsMonitoring/reporting
Portland Water Bureau1 (1 open)1
Tualatin Valley Water DistrictNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Cedar Mill

SiteTypeDistanceMedianSamplesYears
Willamette River at St. John's Bridge
Department of Environmental Quality - State of Oregon
River/Stream 3.9 mi25 mg/L212004–2020
Willamette River at SP&S RR Bridge (Portland)
Department of Environmental Quality - State of Oregon
River/Stream 3.9 mi26 mg/L582000–2024
Willamette River at Cathedral Park Dock
Department of Environmental Quality - State of Oregon
River/Stream 4 mi28 mg/L122023–2025
Willamette River at Cathedral Park
Department of Environmental Quality - State of Oregon
River/Stream 4 mi26 mg/L122020–2021
ROCK CREEK NEAR NW CHERRY LANE, NEAR ORENCO, OR
USGS Oregon Water Science Center
Stream 4.6 mi93 mg/L102015
Swan Island Channel Midpoint
Department of Environmental Quality - State of Oregon
River/Stream 4.7 mi28 mg/L412000–2024

Water hardness in towns near Cedar Mill

TownDistanceMedianClass
Oak Hills2 mi 37 mg/LSoft
Bethany3 mi 28 mg/LSoft
Beaverton4 mi 67 mg/LModerately hard
Aloha5 mi 68 mg/LModerately hard
Hillsboro7 mi 60 mg/LSoft
Portland7 mi 48 mg/LSoft
Tigard8 mi 60 mg/LModerately hard
Lake Oswego10 mi 57 mg/LSoft
Milwaukie11 mi 55 mg/LSoft
Tualatin11 mi 61 mg/LModerately hard

Washington County

Cedar Mill is in Washington County, where the median is 68 mg/L (moderately hard) across 28 sites.

See all of Washington County →

Oregon

The statewide median is 71 mg/L (moderately hard) from 2,142 sites.

Oregon hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next