Water hardness in Hillsboro, OR
Water in Hillsboro is soft, with a median of 60 mg/L (3.5 grains per gallon) across 11 monitoring sites within 10 miles.
Large city utilities sometimes soften, blend or import water from distant reservoirs, so tap water in Hillsboro can differ from local source water. Your utility's annual Consumer Confidence Report lists the exact tap value.
Hillsboro tap water at a glance
- HardnessSoft (60 mg/L, 3.5 gpg, local measurements). A water softener isn't needed.Water heater care →
- PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
- Lead pipesNo lead service lines reported.Details →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 60 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 3.5 gpg (3.4 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Hillsboro
Prefilled with Hillsboro's measured local hardness of 60 mg/L (3.5 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Hillsboro tap water
City of Hillsboro is the main public water system for Hillsboro. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Jul 2023 – Apr 2024. No PFAS were found at or above EPA's minimum reporting levels.
Other water systems serving parts of Hillsboro
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Tualatin Valley Water District serves over 10,000 people | None detected | — | Jul 2023 – May 2024 |
| City of Beaverton serves over 10,000 people | None detected | — | Jul 2023 – Jun 2024 |
| Portland Water Bureau serves over 10,000 people | None detected | — | Feb 2024 – Nov 2024 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Hillsboro
City of Hillsboro reported 28,351 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.
Other water systems serving parts of Hillsboro
| Water system | Service lines | Total |
|---|---|---|
| Tualatin Valley Water District | 0 lead · 0 galvanized · 0 unknown | 62,067 |
| City of Beaverton | 0 lead · 0 galvanized · 0 unknown | 24,061 |
| Portland Water Bureau | 0 lead · 0 galvanized · 0 unknown | 189,613 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Hillsboro drinking water violations
EPA records show no health-based violations for City of Hillsboro since 2016. It also had 2 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
Other water systems serving parts of Hillsboro
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Tualatin Valley Water District | None | 0 |
| City of Beaverton | None | 2 |
| Portland Water Bureau | 1 (1 open) | 1 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Hillsboro
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| BEAVERTON CREEK AT NE 75TH AVE, AT QUATAMA, OR USGS Oregon Water Science Center | Stream | 1.7 mi | 102 mg/L | 10 | 2015 |
| Beaverton Creek at Cornelius Pass Road Department of Environmental Quality - State of Oregon | River/Stream | 1.7 mi | 89 mg/L | 42 | 2000–2024 |
| BEAVERTON CREEK AT SW 216TH AVE, NR ORENCO, OR USGS Oregon Water Science Center | Stream | 1.8 mi | 87 mg/L | 33 | 2003–2006 |
| ROCK CREEK NEAR NW CHERRY LANE, NEAR ORENCO, OR USGS Oregon Water Science Center | Stream | 2 mi | 93 mg/L | 10 | 2015 |
| Tualatin River at Rood Road Department of Environmental Quality - State of Oregon | River/Stream | 2.7 mi | 37 mg/L | 47 | 2000–2024 |
| 01N/02W-17ACC USGS Oregon Water Science Center | Well | 3.2 mi | 225 mg/L | 1 | 2002 |
Water hardness in towns near Hillsboro
| Town | Distance | Median | Class |
|---|---|---|---|
| Aloha | 4 mi | 68 mg/L | Moderately hard |
| Oak Hills | 5 mi | 37 mg/L | Soft |
| Bethany | 5 mi | 28 mg/L | Soft |
| Cornelius | 6 mi | 82 mg/L | Moderately hard |
| Cedar Mill | 7 mi | 65 mg/L | Moderately hard |
| Beaverton | 7 mi | 67 mg/L | Moderately hard |
| Forest Grove | 8 mi | 41 mg/L | Soft |
| Tigard | 10 mi | 60 mg/L | Moderately hard |
| Sherwood | 12 mi | 64 mg/L | Moderately hard |
| Tualatin | 13 mi | 61 mg/L | Moderately hard |
Washington County
Hillsboro is in Washington County, where the median is 68 mg/L (moderately hard) across 28 sites.
See all of Washington County →Hillsboro, OR water: common questions
Do I need a water softener in Hillsboro?
Probably not. Water measured around Hillsboro is 3.5 gpg (60 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →
Who supplies Hillsboro's drinking water?
The main public water system serving Hillsboro in EPA records is City of Hillsboro. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Hillsboro?
Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.