Water hardness in Wasco County, OR
Water in Wasco County is moderately hard, with a median of 64 mg/L (3.8 grains per gallon) across 51 monitoring sites.
Wasco County water at a glance
- HardnessModerately hard (64 mg/L, 3.8 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 64 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 3.8 gpg (3.6 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Wasco County
Prefilled with Wasco County's measured local hardness of 64 mg/L (3.7 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Wasco County on the Oregon map
Cities and communities in Wasco County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| The Dalles | 95 | Moderately hard | 33 sites within 10 miles |
| Chenoweth (CDP) | 66 | Moderately hard | 18 sites within 10 miles |
| Dufur | 63 | Moderately hard | 30 sites within 10 miles |
| Pine Hollow (CDP) | 64 | Moderately hard | county median |
| Mosier | 39 | Soft | 9 sites within 10 miles |
| Maupin | 38 | Soft | 3 sites within 10 miles |
| Tygh Valley (CDP) | 38 | Soft | 3 sites within 10 miles |
| Rowena (CDP) | 77 | Moderately hard | 5 sites within 10 miles |
| Pine Grove (CDP) | 64 | Moderately hard | county median |
| Wamic (CDP) | 64 | Moderately hard | county median |
| Antelope | 64 | Moderately hard | county median |
| Shaniko | 64 | Moderately hard | county median |
| Sportsmans Park (CDP) | 64 | Moderately hard | county median |
Water quality in Wasco County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| The Dalles | City of the Dalles | None detected | 0 lead · 5,014 unknown | None |
| Dufur | City of Dufur | Not tested | 0 lead · 356 unknown | 1 |
| Mosier | City of Mosier | Not tested | 0 lead · 0 unknown | None |
| Maupin | City of Maupin | Not tested | Not reported | 3 (1 open) |
| Tygh Valley | TYGH Valley Water District | Not tested | 0 lead · 0 unknown | 1 |
| Antelope | City of Antelope | Not tested | 0 lead · 0 unknown | None |
| Shaniko | Shaniko Water System | Not tested | 0 lead · 0 unknown | 2 |
Neighboring counties
- Sherman County74 mg/L
- Hood River County34 mg/L
- Jefferson County44 mg/L
- Gilliam County101 mg/L
- Clackamas County23 mg/L
- Wheeler County78 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.