Water hardness in Polk County, OR
Water in Polk County is soft, with a median of 38 mg/L (2.2 grains per gallon) across 26 monitoring sites.
Polk County water at a glance
- HardnessSoft (38 mg/L, 2.2 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 38 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 2.2 gpg (2.1 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Polk County
Prefilled with Polk County's measured local hardness of 38 mg/L (2.2 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Polk County on the Oregon map
Cities and communities in Polk County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Salem | 26 | Soft | 30 sites within 10 miles |
| Dallas | 71 | Moderately hard | 17 sites within 10 miles |
| Monmouth | 36 | Soft | 21 sites within 10 miles |
| Independence | 27 | Soft | 28 sites within 10 miles |
| Willamina | 38 | Soft | county median |
| Grand Ronde (CDP) | 38 | Soft | county median |
| Falls City | 44 | Soft | 8 sites within 10 miles |
| Fort Hill (CDP) | 38 | Soft | county median |
| Rickreall (CDP) | 34 | Soft | 28 sites within 10 miles |
| Eola (CDP) | 34 | Soft | 32 sites within 10 miles |
Water quality in Polk County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Salem | Salem Public Works | None detected | 0 lead · 0 unknown | None |
| Dallas | City of Dallas | None detected | 0 lead · 2,646 unknown | 2 |
| Monmouth | City of Monmouth | None detected | 0 lead · 0 unknown | None |
| Independence | Independence Water System | 1 found | 0 lead · 0 unknown | None |
| Willamina | City of Willamina | Not tested | 0 lead · 0 unknown | None |
| Falls City | City of Falls City | None detected | 0 lead · 0 unknown | None |
Neighboring counties
- Yamhill County96 mg/L
- Benton County118 mg/L
- Lincoln County22 mg/L
- Marion County44 mg/L
- Tillamook County25 mg/L
- Washington County68 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.