Water hardness in Sherman County, OR

Water in Sherman County is moderately hard, with a median of 74 mg/L (4.3 grains per gallon) across 4 monitoring sites.

about the same as the Oregon median (71 mg/L) 15th hardest of 36 counties
74mg/L
4.3 grains per gallon
Moderately hard

Sherman County water at a glance

  • HardnessModerately hard (74 mg/L, 4.3 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 74 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 4.3 gpg (4.1 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites4
Lab samples40
Sample years2009–2024
Middle 50% of sites64–88 mg/L
Groundwater (wells, springs)98 mg/L · 1 sites
Surface water (rivers, lakes)64 mg/L · 3 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Sherman County

Prefilled with Sherman County's measured local hardness of 74 mg/L (4.3 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Sherman County on the Oregon map

Grant CountyWasco CountyWheeler CountyBaker CountyGilliam CountyHarney CountyKlamath CountyWashington CountyLane CountyLake CountyJefferson CountyDeschutes CountyTillamook CountyColumbia CountyLinn CountyMorrow CountyCoos CountyJosephine CountyUnion CountyLincoln CountyUmatilla CountyWallowa CountyClackamas CountyCurry CountyMalheur CountyBenton CountyHood River CountyPolk CountyCrook CountyMultnomah CountyYamhill CountyClatsop CountyJackson CountyMarion CountyDouglas County

Cities and communities in Sherman County

PlaceMedian mg/LClassBased on
Wasco 74 Moderately hard county median
Moro 74 Moderately hard county median
Rufus 64 Moderately hard 5 sites within 10 miles
Grass Valley 74 Moderately hard county median
Biggs Junction (CDP) 144 Hard 10 sites within 10 miles

Water quality in Sherman County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Wasco City of Wasco Not tested 0 lead · 0 unknown 1
Moro City of Moro Not tested 0 lead · 0 unknown None
Rufus Rufus Public Works Not tested 0 lead · 0 unknown None
Grass Valley Grass Valley Water System Not tested 0 lead · 0 unknown None

Neighboring counties

Oregon

The statewide median is 71 mg/L (moderately hard) from 2,142 sites.

Oregon hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next