Water hardness in Renville County, ND

Water in Renville County is very hard, with a median of 288 mg/L (16.8 grains per gallon) across 3 monitoring sites.

22% softer than the North Dakota median (368 mg/L) 41st hardest of 53 counties
288mg/L
16.8 grains per gallon
Very hard

Renville County water at a glance

  • HardnessVery hard (288 mg/L, 16.8 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 288 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 16.8 gpg (16.1 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites3
Lab samples219
Sample years2000–2023
Middle 50% of sites285–335 mg/L
Groundwater (wells, springs)282 mg/L · 1 sites
Surface water (rivers, lakes)335 mg/L · 2 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Renville County

Prefilled with Renville County's measured local hardness of 288 mg/L (16.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Renville County on the North Dakota map

Burke CountyFoster CountyGriggs CountyHettinger CountyLogan CountyOliver CountyLaMoure CountyPierce CountyWells CountySheridan CountyKidder CountyCavalier CountyStark CountyBarnes CountyEddy CountyRichland CountyStutsman CountyRansom CountyRolette CountySlope CountyBottineau CountyWalsh CountyAdams CountyWilliams CountyMcIntosh CountyMorton CountyDunn CountyMcKenzie CountySteele CountyTowner CountyMcLean CountyMercer CountyDivide CountyWard CountySargent CountyBillings CountyMcHenry CountyBowman CountyGrant CountyGrand Forks CountyRamsey CountyPembina CountyEmmons CountyTraill CountyBenson CountyNelson CountyMountrail CountySioux CountyDickey CountyCass CountyBurleigh CountyGolden Valley County

Cities and communities in Renville County

PlaceMedian mg/LClassBased on
Mohall 288 Very hard county median
Glenburn 288 Very hard county median
Sherwood 288 Very hard county median
Tolley 288 Very hard county median
Grano 288 Very hard county median
Loraine 288 Very hard county median

Water quality in Renville County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Mohall City of Mohall Not tested 4 lead · 419 unknown None
Glenburn City of Glenburn Not tested 0 lead · 147 unknown None
Sherwood City of Sherwood Not tested 1 lead · 131 unknown None

Neighboring counties

North Dakota

The statewide median is 368 mg/L (very hard) from 747 sites.

North Dakota hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next