Water hardness in Steele County, ND

Water in Steele County is very hard, with a median of 617 mg/L (36 grains per gallon) across 7 monitoring sites.

68% harder than the North Dakota median (368 mg/L) 4th hardest of 53 counties
617mg/L
36 grains per gallon
Very hard

Steele County water at a glance

  • HardnessVery hard (617 mg/L, 36 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 617 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 36 gpg (34.6 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites7
Lab samples49
Sample years2000–2012
Middle 50% of sites526–620 mg/L
Groundwater (wells, springs)160 mg/L · 1 sites
Surface water (rivers, lakes)618 mg/L · 6 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Steele County

Prefilled with Steele County's measured local hardness of 617 mg/L (36.1 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Steele County on the North Dakota map

Burke CountyFoster CountyGriggs CountyHettinger CountyLogan CountyRenville CountyOliver CountyLaMoure CountyPierce CountyWells CountySheridan CountyKidder CountyCavalier CountyStark CountyBarnes CountyEddy CountyRichland CountyStutsman CountyRansom CountyRolette CountySlope CountyBottineau CountyWalsh CountyAdams CountyWilliams CountyMcIntosh CountyMorton CountyDunn CountyMcKenzie CountyTowner CountyMcLean CountyMercer CountyDivide CountyWard CountySargent CountyBillings CountyMcHenry CountyBowman CountyGrant CountyGrand Forks CountyRamsey CountyPembina CountyEmmons CountyTraill CountyBenson CountyNelson CountyMountrail CountySioux CountyDickey CountyCass CountyBurleigh CountyGolden Valley County

Cities and communities in Steele County

PlaceMedian mg/LClassBased on
Finley 485 Very hard 6 sites within 10 miles
Hope 617 Very hard county median
Sharon 480 Very hard 4 sites within 10 miles
Luverne 434 Very hard 23 sites within 10 miles

Water quality in Steele County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Finley City of Finley Not tested 0 lead · 63 unknown None
Hope City of Hope Not tested 2 lead · 60 unknown None
Sharon City of Sharon Not tested 0 lead · 43 unknown None

Neighboring counties

North Dakota

The statewide median is 368 mg/L (very hard) from 747 sites.

North Dakota hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next