Water hardness in Logan County, ND

Water in Logan County is very hard, with a median of 344 mg/L (20.1 grains per gallon) across 5 monitoring sites.

about the same as the North Dakota median (368 mg/L) 35th hardest of 53 counties
344mg/L
20.1 grains per gallon
Very hard

Logan County water at a glance

  • HardnessVery hard (344 mg/L, 20.1 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 344 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 20.1 gpg (19.3 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites5
Lab samples11
Sample years2001–2016
Middle 50% of sites216–384 mg/L
Groundwater (wells, springs)344 mg/L · 5 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Logan County

Prefilled with Logan County's measured local hardness of 344 mg/L (20.1 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Logan County on the North Dakota map

Burke CountyFoster CountyGriggs CountyHettinger CountyRenville CountyOliver CountyLaMoure CountyPierce CountyWells CountySheridan CountyKidder CountyCavalier CountyStark CountyBarnes CountyEddy CountyRichland CountyStutsman CountyRansom CountyRolette CountySlope CountyBottineau CountyWalsh CountyAdams CountyWilliams CountyMcIntosh CountyMorton CountyDunn CountyMcKenzie CountySteele CountyTowner CountyMcLean CountyMercer CountyDivide CountyWard CountySargent CountyBillings CountyMcHenry CountyBowman CountyGrant CountyGrand Forks CountyRamsey CountyPembina CountyEmmons CountyTraill CountyBenson CountyNelson CountyMountrail CountySioux CountyDickey CountyCass CountyBurleigh CountyGolden Valley County

Cities and communities in Logan County

PlaceMedian mg/LClassBased on
Napoleon 280 Very hard 4 sites within 10 miles
Gackle 344 Very hard county median
Fredonia 344 Very hard county median

Water quality in Logan County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Napoleon City of Napoleon Not tested 0 lead · 168 unknown None
Gackle City of Gackle Not tested 2 lead · 232 unknown None

Neighboring counties

North Dakota

The statewide median is 368 mg/L (very hard) from 747 sites.

North Dakota hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next