Water hardness in Wrangell City and Borough, AK
Water in Wrangell City and Borough is soft, with a median of 59 mg/L (3.4 grains per gallon) across 2 monitoring sites.
Wrangell City and Borough water at a glance
- HardnessSoft (59 mg/L, 3.4 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 59 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 3.4 gpg (3.3 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Wrangell City and Borough
Prefilled with Wrangell City and Borough's measured local hardness of 59 mg/L (3.5 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Wrangell City and Borough on the Alaska map
Cities and communities in Wrangell City and Borough
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Wrangell | 59 | Soft | county median |
Water quality in Wrangell City and Borough communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Wrangell | Wrangell | Not tested | 0 lead · 0 unknown | 9 |
Neighboring counties
- Prince of Wales-Hyder Census Area23 mg/L
- Ketchikan Gateway Borough10 mg/L
- Petersburg Borough5 mg/L
- Sitka City and Borough15 mg/L
- Juneau City and Borough64 mg/L
- Hoonah-Angoon Census Area78 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.