Water hardness in Skagway Municipality, AK

Water in Skagway Municipality is soft, with a median of 30 mg/L (1.8 grains per gallon) across 1 monitoring site.

56% softer than the Alaska median (68 mg/L) 19th hardest of 25 counties
30mg/L
1.8 grains per gallon
Soft

Skagway Municipality water at a glance

  • HardnessSoft (30 mg/L, 1.8 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 30 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 1.8 gpg (1.7 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites1
Lab samples5
Sample years2003–2004
Middle 50% of sites30–30 mg/L
Surface water (rivers, lakes)30 mg/L · 1 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Skagway Municipality

Prefilled with Skagway Municipality's measured local hardness of 30 mg/L (1.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Skagway Municipality on the Alaska map

Lake and Peninsula BoroughKetchikan Gateway BoroughHaines BoroughWrangell City and BoroughHoonah-Angoon Census AreaAleutians West Census AreaBethel Census AreaSoutheast Fairbanks Census AreaKusilvak Census AreaYukon-Koyukuk Census AreaNorth Slope BoroughNome Census AreaSitka City and BoroughPetersburg BoroughBristol Bay BoroughAleutians East BoroughKodiak Island BoroughPrince of Wales-Hyder Census AreaChugach Census AreaCopper River Census AreaDillingham Census AreaKenai Peninsula BoroughAnchorage MunicipalityNorthwest Arctic BoroughFairbanks North Star BoroughJuneau City and BoroughDenali BoroughMatanuska-Susitna BoroughYakutat City and Borough

Cities and communities in Skagway Municipality

PlaceMedian mg/LClassBased on
Skagway (CDP) 30 Soft county median

Water quality in Skagway Municipality communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Skagway Skagway None detected 0 lead · 0 unknown 2

Alaska

The statewide median is 68 mg/L (moderately hard) from 280 sites.

Alaska hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next