Water hardness in Lauderdale County, AL
Water in Lauderdale County is soft, with a median of 48 mg/L (2.8 grains per gallon) across 53 monitoring sites.
Lauderdale County water at a glance
- HardnessSoft (48 mg/L, 2.8 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 48 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 2.8 gpg (2.7 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Lauderdale County
Prefilled with Lauderdale County's measured local hardness of 48 mg/L (2.8 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Lauderdale County on the Alabama map
Cities and communities in Lauderdale County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Florence | 73 | Moderately hard | 34 sites within 10 miles |
| Underwood-Petersville (CDP) | 67 | Moderately hard | 30 sites within 10 miles |
| Rogersville | 58 | Soft | 29 sites within 10 miles |
| Killen | 67 | Moderately hard | 38 sites within 10 miles |
| Lexington | 48 | Soft | 15 sites within 10 miles |
| St. Florian | 60 | Soft | 34 sites within 10 miles |
| Anderson | 54 | Soft | 26 sites within 10 miles |
| Waterloo | 10 | Soft | 11 sites within 10 miles |
Water quality in Lauderdale County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Florence | Florence Water-Wastewater Department | 5 found (PFOA 9.7 / PFOS 17 ppt) | 2 lead · 17,542 unknown | None |
| Rogersville | Rogersville Water Works & Sewer Board | 8 found (PFOA 10.2 / PFOS 12.3 ppt) | 0 lead · 81 unknown | None |
| Lexington | Lexington Water Works | Not tested | 0 lead · 57 unknown | None |
Neighboring counties
- Colbert County85 mg/L
- Lawrence County120 mg/L
- Franklin County64 mg/L
- Limestone County65 mg/L
- Winston County17 mg/L
- Marion County12 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.