Water hardness in St. Clair County, AL
Water in St. Clair County is moderately hard, with a median of 72 mg/L (4.2 grains per gallon) across 31 monitoring sites.
St. Clair County water at a glance
- HardnessModerately hard (72 mg/L, 4.2 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 72 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 4.2 gpg (4 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for St. Clair County
Prefilled with St. Clair County's measured local hardness of 72 mg/L (4.2 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
St. Clair County on the Alabama map
Cities and communities in St. Clair County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Trussville | 136 | Hard | 12 sites within 10 miles |
| Pell City | 68 | Moderately hard | 15 sites within 10 miles |
| Moody | 99 | Moderately hard | 14 sites within 10 miles |
| Margaret | 102 | Moderately hard | 11 sites within 10 miles |
| Odenville | 85 | Moderately hard | 6 sites within 10 miles |
| Springville | 90 | Moderately hard | 8 sites within 10 miles |
| Argo | 99 | Moderately hard | 10 sites within 10 miles |
| Ashville | 101 | Moderately hard | 12 sites within 10 miles |
| Riverside | 75 | Moderately hard | 14 sites within 10 miles |
| Ragland | 80 | Moderately hard | 17 sites within 10 miles |
| Steele | 97 | Moderately hard | 15 sites within 10 miles |
Water quality in St. Clair County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Trussville | Trussville Utilities | None detected | 0 lead · 0 unknown | None |
| Pell City | Pell City Water Works | 7 found (PFOA 15 / PFOS 5.5 ppt) | 0 lead · 0 unknown | None |
| Margaret | Town of Margaret, the WWB of the | 4 found | 0 lead · 64 unknown | None |
| Odenville | Town of Odenville, Utillities BD. of the | 5 found (PFOA 4.9 / PFOS ND ppt) | 0 lead · 0 unknown | None |
| Springville | City of Springville | 5 found (PFOA 4.1 / PFOS ND ppt) | 0 lead · 8 unknown | None |
| Ashville | City of Ashville | None detected | 0 lead · 0 unknown | None |
| Riverside | City of Riverside | None detected | 0 lead · 0 unknown | None |
| Ragland | Town of Ragland, the WWB of the | Not tested | 0 lead · 0 unknown | None |
| Steele | Steele Water Works Board | Not tested | 0 lead · 0 unknown | 1 (1 open) |
Neighboring counties
- Blount County83 mg/L
- Talladega County90 mg/L
- Etowah County94 mg/L
- Calhoun County107 mg/L
- Jefferson County167 mg/L
- Shelby County118 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.