Water hardness in Washington County, AL
Water in Washington County is soft, with a median of 4 mg/L (0.2 grains per gallon) across 14 monitoring sites.
Washington County water at a glance
- HardnessSoft (4 mg/L, 0.2 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 4 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 0.2 gpg (0.2 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Washington County
Prefilled with Washington County's measured local hardness of 4 mg/L (0.2 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Washington County on the Alabama map
Cities and communities in Washington County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Chatom | 4 | Soft | 4 sites within 10 miles |
| Leroy (CDP) | 18 | Soft | 7 sites within 10 miles |
| St. Stephens (CDP) | 41 | Soft | 5 sites within 10 miles |
| Millry | 4 | Soft | county median |
| Calvert (CDP) | 55 | Soft | 9 sites within 10 miles |
| McIntosh | 5 | Soft | 5 sites within 10 miles |
| Vinegar Bend (CDP) | 4 | Soft | 3 sites within 10 miles |
| Deer Park (CDP) | 4 | Soft | 3 sites within 10 miles |
| Malcolm (CDP) | 51 | Soft | 9 sites within 10 miles |
| Fairford (CDP) | 28 | Soft | 6 sites within 10 miles |
| Fruitdale (CDP) | 4 | Soft | county median |
| Sims Chapel (CDP) | 4 | Soft | 3 sites within 10 miles |
| Hobson (CDP) | 4 | Soft | 5 sites within 10 miles |
| Tibbie (CDP) | 4 | Soft | 4 sites within 10 miles |
Water quality in Washington County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Chatom | Chatom, the Utilities Board of the Town | Not tested | 0 lead · 1 unknown | None |
| Leroy | Leroy Water Authority | Not tested | 0 lead · 2 unknown | 1 |
| St. Stephens | ST Stephens Water System | Not tested | 0 lead · 1 unknown | None |
| Millry | Town of Millry, the UB of the | Not tested | 0 lead · 33 unknown | None |
| McIntosh | Mcintosh Water & Fire Pro Authority | None detected | 0 lead · 0 unknown | None |
| Deer Park | Deer Park-Vinegar Bend Water & Fpa | None detected | 0 lead · 0 unknown | None |
| Fruitdale | Fruitdale Water System | Not tested | 0 lead · 0 unknown | None |
| Hobson | Hobson City Water System | Not tested | 12 lead · 0 unknown | None |
| Tibbie | Tibbie Water & Fire Protection Authority | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Clarke County41 mg/L
- Choctaw County55 mg/L
- Mobile County22 mg/L
- Monroe County31 mg/L
- Baldwin County21 mg/L
- Marengo County58 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.