Water hardness in Hot Springs County, WY

Water in Hot Springs County is very hard, with a median of 216 mg/L (12.6 grains per gallon) across 1 monitoring site.

13% harder than the Wyoming median (192 mg/L) 12th hardest of 23 counties
216mg/L
12.6 grains per gallon
Very hard

Hot Springs County water at a glance

  • HardnessVery hard (216 mg/L, 12.6 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 216 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 12.6 gpg (12.1 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites1
Lab samples8
Sample years2002–2016
Middle 50% of sites216–216 mg/L
Surface water (rivers, lakes)216 mg/L · 1 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Hot Springs County

Prefilled with Hot Springs County's measured local hardness of 216 mg/L (12.6 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Hot Springs County on the Wyoming map

Lincoln CountyPlatte CountyWashakie CountyPark CountyUinta CountyCampbell CountyConverse CountyGoshen CountyTeton CountyNatrona CountyNiobrara CountySweetwater CountySublette CountyBig Horn CountyAlbany CountyFremont CountyCarbon CountyCrook CountyLaramie CountyJohnson CountySheridan CountyWeston County

Cities and communities in Hot Springs County

PlaceMedian mg/LClassBased on
Thermopolis 216 Very hard county median
Lucerne (CDP) 216 Very hard county median
East Thermopolis 216 Very hard county median
Kirby 216 Very hard county median
Owl Creek (CDP) 216 Very hard county median

Water quality in Hot Springs County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Thermopolis Town of Thermopolis Not tested 9 lead · 1,085 unknown None
East Thermopolis Town of East Thermopolis Not tested 0 lead · 0 unknown None
Kirby Town of Kirby Not tested 0 lead · 111 unknown None
Owl Creek OWL Creek Water District Not tested 0 lead · 0 unknown 6

Neighboring counties

Wyoming

The statewide median is 192 mg/L (very hard) from 810 sites.

Wyoming hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next