Water hardness in Park County, WY

Water in Park County is soft, with a median of 21 mg/L (1.2 grains per gallon) across 72 monitoring sites.

89% softer than the Wyoming median (192 mg/L) 23rd hardest of 23 counties
21mg/L
1.2 grains per gallon
Soft

Park County water at a glance

  • HardnessSoft (21 mg/L, 1.2 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 21 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 1.2 gpg (1.2 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites72
Lab samples315
Sample years2000–2019
Middle 50% of sites12–60 mg/L
Groundwater (wells, springs)19 mg/L · 61 sites
Surface water (rivers, lakes)43 mg/L · 11 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Park County

Prefilled with Park County's measured local hardness of 21 mg/L (1.2 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Park County on the Wyoming map

Lincoln CountyPlatte CountyWashakie CountyUinta CountyCampbell CountyConverse CountyGoshen CountyTeton CountyNatrona CountyNiobrara CountySweetwater CountySublette CountyBig Horn CountyHot Springs CountyAlbany CountyFremont CountyCarbon CountyCrook CountyLaramie CountyJohnson CountySheridan CountyWeston County

Cities and communities in Park County

PlaceMedian mg/LClassBased on
Cody 239 Very hard 3 sites within 10 miles
Powell 320 Very hard 4 sites within 10 miles
Meeteetse 21 Soft county median
Ralston (CDP) 161 Hard 3 sites within 10 miles
Mammoth (CDP) 191 Very hard 5 sites within 10 miles
Garland (CDP) 486 Very hard 3 sites within 10 miles

Water quality in Park County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Cody City of Cody None detected 5 lead · 3,803 unknown None
Powell City of Powell None detected 0 lead · 2,654 unknown None
Meeteetse Town of Meeteetse Not tested 0 lead · 175 unknown None

Neighboring counties

Wyoming

The statewide median is 192 mg/L (very hard) from 810 sites.

Wyoming hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next