Water hardness in Albany County, WY

Water in Albany County is very hard, with a median of 182 mg/L (10.6 grains per gallon) across 31 monitoring sites.

about the same as the Wyoming median (192 mg/L) 15th hardest of 23 counties
182mg/L
10.6 grains per gallon
Very hard

Albany County water at a glance

  • HardnessVery hard (182 mg/L, 10.6 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 182 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 10.6 gpg (10.2 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites31
Lab samples35
Sample years2012–2016
Middle 50% of sites108–231 mg/L
Groundwater (wells, springs)182 mg/L · 31 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Albany County

Prefilled with Albany County's measured local hardness of 182 mg/L (10.6 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Albany County on the Wyoming map

Lincoln CountyPlatte CountyWashakie CountyPark CountyUinta CountyCampbell CountyConverse CountyGoshen CountyTeton CountyNatrona CountyNiobrara CountySweetwater CountySublette CountyBig Horn CountyHot Springs CountyFremont CountyCarbon CountyCrook CountyLaramie CountyJohnson CountySheridan CountyWeston County

Cities and communities in Albany County

PlaceMedian mg/LClassBased on
Laramie 212 Very hard 9 sites within 10 miles
Centennial (CDP) 118 Moderately hard 3 sites within 10 miles
Rock River 182 Very hard county median
Woods Landing-Jelm (CDP) 171 Hard 3 sites within 10 miles
Albany (CDP) 144 Hard 4 sites within 10 miles
Fox Park (CDP) 182 Very hard county median

Water quality in Albany County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Laramie City of Laramie None detected 0 lead · 0 unknown None
Centennial Centennial Water and Sewer District Not tested 0 lead · 0 unknown None
Rock River Town of Rock River Not tested 0 lead · 32 unknown None

Neighboring counties

Wyoming

The statewide median is 192 mg/L (very hard) from 810 sites.

Wyoming hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next