Water hardness in Port Townsend, WA
Water in Port Townsend is soft, with a median of 25 mg/L (1.5 grains per gallon) across Jefferson County.
There are not enough monitoring sites within 10 miles of Port Townsend, so this page uses the Jefferson County median.
Port Townsend tap water at a glance
- HardnessSoft (25 mg/L, 1.5 gpg, local measurements). A water softener isn't needed.Water heater care →
- PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
- Lead pipesNo lead service lines reported.Details →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 25 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 1.5 gpg (1.4 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Port Townsend
Prefilled with Port Townsend's measured local hardness of 25 mg/L (1.5 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Port Townsend tap water
City of Port Townsend is the main public water system for Port Townsend. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Sep 2024 – Jun 2025. No PFAS were found at or above EPA's minimum reporting levels.
Other water systems serving parts of Port Townsend
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Quimper serves over 10,000 people | PFBS | — | Sep 2023 – Mar 2024 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Port Townsend
City of Port Townsend reported 5,204 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.
Other water systems serving parts of Port Townsend
| Water system | Service lines | Total |
|---|---|---|
| Quimper | 0 lead · 0 galvanized · 0 unknown | 254 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Port Townsend drinking water violations
EPA records show no health-based violations for City of Port Townsend since 2016.
Other water systems serving parts of Port Townsend
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Quimper | None | 2 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Port Townsend
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| 31N/01E-14B02 USGS Washington Water Science Center | Well | 7.6 mi | 289 mg/L | 1 | 2014 |
Water hardness in towns near Port Townsend
| Town | Distance | Median | Class |
|---|---|---|---|
| Oak Harbor | 14 mi | 289 mg/L | Very hard |
| Anacortes | 26 mi | 9 mg/L | Soft |
| Mukilteo | 27 mi | 31 mg/L | Soft |
| Poulsbo | 27 mi | 89 mg/L | Moderately hard |
| Edmonds | 29 mi | 98 mg/L | Moderately hard |
| Marysville | 29 mi | 29 mg/L | Soft |
| Everett | 30 mi | 66 mg/L | Moderately hard |
| Arlington | 30 mi | 36 mg/L | Soft |
| Mount Vernon | 30 mi | 9 mg/L | Soft |
| North Lynnwood | 30 mi | 82 mg/L | Moderately hard |
Jefferson County
Port Townsend is in Jefferson County, where the median is 25 mg/L (soft) across 3 sites.
See all of Jefferson County →Washington
The statewide median is 74 mg/L (moderately hard) from 890 sites.
Washington hardness map →Port Townsend, WA water: common questions
Do I need a water softener in Port Townsend?
Probably not. Water measured around Port Townsend is 1.5 gpg (25 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →
Who supplies Port Townsend's drinking water?
The main public water system serving Port Townsend in EPA records is City of Port Townsend. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Port Townsend?
Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.