Water hardness in Oak Harbor, WA

Water in Oak Harbor is very hard, with a median of 289 mg/L (16.9 grains per gallon) across Island County.

291% harder than the Washington median (74 mg/L) 1st hardest of 122 Washington towns Population 24,016
289mg/L
16.9 grains per gallon
Very hard

There are not enough monitoring sites within 10 miles of Oak Harbor, so this page uses the Island County median.

Oak Harbor tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 289 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 16.9 gpg (16.2 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites1
Lab samples1
Sample years2014–2014
Middle 50% of sites289–289 mg/L
Groundwater (wells, springs)289 mg/L · 1 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Oak Harbor

Prefilled with Oak Harbor's measured local hardness of 289 mg/L (16.9 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Oak Harbor tap water

City of Oak Harbor is the main public water system for Oak Harbor. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Feb 2024 – Nov 2024. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Oak Harbor

Water systemPFAS detectedHighest PFOA / PFOSTested
City of Anacortes
serves over 10,000 people
None detected — Mar 2023 – Dec 2023

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Oak Harbor

City of Oak Harbor reported 6,144 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
6,144not lead (100%)

Other water systems serving parts of Oak Harbor

Water systemService linesTotal
City of Anacortes0 lead · 32 galvanized · 7,858 unknown18,574

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Oak Harbor drinking water violations

EPA records show no health-based violations for City of Oak Harbor since 2016. It also had 2 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Oak Harbor

Water systemHealth-based violationsMonitoring/reporting
City of AnacortesNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Oak Harbor

SiteTypeDistanceMedianSamplesYears
31N/01E-14B02
USGS Washington Water Science Center
Well 8 mi289 mg/L12014

Water hardness in towns near Oak Harbor

TownDistanceMedianClass
Anacortes13 mi 9 mg/LSoft
Port Townsend14 mi 25 mg/LSoft
Mount Vernon17 mi 9 mg/LSoft
Burlington18 mi 9 mg/LSoft
Sedro-Woolley24 mi 9 mg/LSoft
Arlington24 mi 36 mg/LSoft
Marysville26 mi 29 mg/LSoft
Mukilteo30 mi 31 mg/LSoft
Everett30 mi 66 mg/LModerately hard
Lake Stevens32 mi 37 mg/LSoft

Island County

Oak Harbor is in Island County, where the median is 289 mg/L (very hard) across 1 sites.

See all of Island County →

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Oak Harbor, WA water: common questions

Do I need a water softener in Oak Harbor?

Very likely. Water measured around Oak Harbor is 16.9 gpg (289 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 30,000 grains.Size it for your household →

Who supplies Oak Harbor's drinking water?

The main public water system serving Oak Harbor in EPA records is City of Oak Harbor. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Oak Harbor?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next