Water hardness in Arlington, WA
Water in Arlington is soft, with a median of 36 mg/L (2.1 grains per gallon) across 57 monitoring sites within 10 miles.
Arlington tap water at a glance
- HardnessSoft (36 mg/L, 2.1 gpg, local measurements). A water softener isn't needed.Water heater care →
- PFAS1 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
- Lead pipesNo known lead lines; 983 lines are still of unknown material.Check your own pipe →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 36 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 2.1 gpg (2 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Arlington
Prefilled with Arlington's measured local hardness of 36 mg/L (2.1 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Arlington tap water
Arlington Water Dept is the main public water system for Arlington. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 10 samples taken Feb 2023 – Dec 2023. 1 PFAS was detected. Every result with a federal limit was at or below it.
| Chemical | Highest result | Detected in | EPA limit |
|---|---|---|---|
| PFHxS perfluorohexane sulfonic acid | 4.9 ppt | 2 of 10 samples | 10 ppt* |
Other water systems serving parts of Arlington
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Marysville Utilities serves over 10,000 people | None detected | — | Mar 2023 – Dec 2023 |
| Sno Pud 1 - Lake Stevens serves over 10,000 people | None detected | — | Jan 2024 – Dec 2024 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Arlington
City of Arlington reported 5,774 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 983 lines are still of unknown material.
Other water systems serving parts of Arlington
| Water system | Service lines | Total |
|---|---|---|
| Marysville Utilities | 0 lead · 0 galvanized · 0 unknown | 23,199 |
| Sno Pud 1 - Lake Stevens | 0 lead · 0 galvanized · 0 unknown | 21,499 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Arlington drinking water violations
EPA records show no health-based violations for Arlington Water Dept since 2016.
Other water systems serving parts of Arlington
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Marysville Utilities | None | 4 |
| Sno Pud 1 - Lake Stevens | None | 2 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Arlington
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| Main Stilly Stillaguamish Tribe of Indians of Washington (Tribal) | River/Stream | 0.8 mi | 25 mg/L | 719 | 2000–2008 |
| Portage Cr @ Hwy#9 Stillaguamish Tribe of Indians of Washington (Tribal) | River/Stream | 1.1 mi | 31 mg/L | 855 | 2000–2015 |
| Portage Cr @ 80th Ave Stillaguamish Tribe of Indians of Washington (Tribal) | River/Stream | 1.3 mi | 23 mg/L | 385 | 2003–2008 |
| Main Stilly Stillaguamish Tribe of Indians of Washington (Tribal) | River/Stream | 1.6 mi | 29 mg/L | 733 | 2002–2015 |
| Main Stily Stillaguamish Tribe of Indians of Washington (Tribal) | River/Stream | 2 mi | 40 mg/L | 632 | 2000–2008 |
| SF Stillaguamish R @ Lincoln Park Br Stillaguamish Tribe of Indians of Washington (Tribal) | River/Stream | 2.4 mi | 20 mg/L | 637 | 2000–2008 |
Water hardness in towns near Arlington
| Town | Distance | Median | Class |
|---|---|---|---|
| Marysville | 6 mi | 29 mg/L | Soft |
| Lake Stevens | 12 mi | 37 mg/L | Soft |
| Everett | 14 mi | 66 mg/L | Moderately hard |
| Snohomish | 17 mi | 38 mg/L | Soft |
| Mount Vernon | 19 mi | 9 mg/L | Soft |
| Eastmont | 19 mi | 70 mg/L | Moderately hard |
| Mukilteo | 19 mi | 31 mg/L | Soft |
| Silver Firs | 21 mi | 70 mg/L | Moderately hard |
| Mill Creek | 21 mi | 82 mg/L | Moderately hard |
| Burlington | 22 mi | 9 mg/L | Soft |
Snohomish County
Arlington is in Snohomish County, where the median is 31 mg/L (soft) across 99 sites.
See all of Snohomish County →Washington
The statewide median is 74 mg/L (moderately hard) from 890 sites.
Washington hardness map →Arlington, WA water: common questions
Do I need a water softener in Arlington?
Probably not. Water measured around Arlington is 2.1 gpg (36 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →
Who supplies Arlington's drinking water?
The main public water system serving Arlington in EPA records is Arlington Water Dept. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Arlington?
It depends on what you want to remove. In Arlington, EPA testing found PFHxS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →
Hardness scale
What to read next
- Which water filters remove PFAS?EPA tests found 1 PFAS in Arlington's main water system.
- How to tell if your home has a lead pipe983 service lines here are of unknown material.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.