Water hardness in Taylorsville, UT
Water in Taylorsville is very hard, with a median of 370 mg/L (21.6 grains per gallon) across 212 monitoring sites within 10 miles.
Taylorsville tap water at a glance
- HardnessVery hard (370 mg/L, 21.6 gpg, local measurements). Water softeners are common at this level.Size a water softener →
- PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
- Lead pipesNo lead service lines reported.Details →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 370 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 21.6 gpg (20.7 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Taylorsville
Prefilled with Taylorsville's measured local hardness of 370 mg/L (21.6 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Taylorsville tap water
Taylorsville-Bennion is the main public water system for Taylorsville. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 14 samples taken Jul 2024 – Jun 2025. No PFAS were found at or above EPA's minimum reporting levels.
Other water systems serving parts of Taylorsville
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Jordan Valley WCD serves over 10,000 people | None detected | — | Aug 2023 – May 2025 |
| Kearns Improvement District serves over 10,000 people | None detected | — | Feb 2024 – Feb 2025 |
| Granger-Hunter Improvement District serves over 10,000 people | None detected | — | Jun 2023 – Mar 2024 |
| West Jordan City Water System serves over 10,000 people | PFHxA, PFPeA, PFBS | — | Aug 2023 – Dec 2024 |
| Murray City Water System serves over 10,000 people | PFPeA, PFBS, PFHxA +4 more | 4 / ND ppt | Apr 2024 – Feb 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Taylorsville
Taylorsville-Bennion reported 17,354 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.
Other water systems serving parts of Taylorsville
| Water system | Service lines | Total |
|---|---|---|
| Jordan Valley WCD | 0 lead · 0 galvanized · 0 unknown | 8,578 |
| Kearns Improvement District | 0 lead · 0 galvanized · 0 unknown | 14,633 |
| Granger-Hunter Improvement District | 0 lead · 0 galvanized · 0 unknown | 27,283 |
| West Jordan City Water System | 0 lead · 0 galvanized · 0 unknown | 26,272 |
| Murray City Water System | 0 lead · 17 galvanized · 291 unknown | 10,346 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Taylorsville drinking water violations
EPA records show no health-based violations for Taylorsville-Bennion since 2016. It also had 5 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
Other water systems serving parts of Taylorsville
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Jordan Valley WCD | None | 2 |
| Kearns Improvement District | 4 | 26 |
| Granger-Hunter Improvement District | None | 2 |
| West Jordan City Water System | None | 57 |
| Murray City Water System | None | 8 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Taylorsville
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| (C- 2- 1) 9ddd- 1 USGS Utah Water Science Center | Well | 0.2 mi | 900 mg/L | 2 | 2012–2020 |
| (C- 2- 1)10bcb- 1 USGS Utah Water Science Center | Well | 0.4 mi | 1230 mg/L | 1 | 2012 |
| (C- 2- 1)10ddc- 1 USGS Utah Water Science Center | Well | 0.9 mi | 671 mg/L | 2 | 2012–2020 |
| (C- 2- 1) 9bcc- 1 USGS Utah Water Science Center | Well | 0.9 mi | 570 mg/L | 2 | 2012–2020 |
| (C- 2- 1) 9ccc- 3 USGS Utah Water Science Center | Well | 0.9 mi | 536 mg/L | 2 | 2012–2020 |
| (C- 2- 1) 4dcb- 1 USGS Utah Water Science Center | Well | 1 mi | 656 mg/L | 2 | 2012–2020 |
Water hardness in towns near Taylorsville
| Town | Distance | Median | Class |
|---|---|---|---|
| Kearns metro township | 3 mi | 397 mg/L | Very hard |
| Murray | 3 mi | 356 mg/L | Very hard |
| West Valley City | 4 mi | 176 mg/L | Hard |
| Midvale | 4 mi | 364 mg/L | Very hard |
| South Salt Lake | 4 mi | 350 mg/L | Very hard |
| West Jordan | 5 mi | 183 mg/L | Very hard |
| Holladay | 7 mi | 351 mg/L | Very hard |
| Millcreek | 7 mi | 344 mg/L | Very hard |
| South Jordan | 7 mi | 404 mg/L | Very hard |
| Cottonwood Heights | 8 mi | 346 mg/L | Very hard |
Salt Lake County
Taylorsville is in Salt Lake County, where the median is 369 mg/L (very hard) across 381 sites.
See all of Salt Lake County →Taylorsville, UT water: common questions
Do I need a water softener in Taylorsville?
Very likely. Water measured around Taylorsville is 21.6 gpg (370 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 38,000 grains.Size it for your household →
Who supplies Taylorsville's drinking water?
The main public water system serving Taylorsville in EPA records is Taylorsville-Bennion. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Taylorsville?
Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →
Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.