Water hardness in Millcreek, UT
Water in Millcreek is very hard, with a median of 344 mg/L (20.1 grains per gallon) across 224 monitoring sites within 10 miles.
Millcreek tap water at a glance
- HardnessVery hard (344 mg/L, 20.1 gpg, local measurements). Water softeners are common at this level.Size a water softener →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 344 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 20.1 gpg (19.3 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Millcreek
Prefilled with Millcreek's measured local hardness of 344 mg/L (20.1 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Millcreek tap water
Millcreek is served by more than one water system. These systems supply ZIP codes in Millcreek and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.
Water systems serving Millcreek
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Salt Lake City Water System serves over 10,000 people | PFHxS, PFOS, PFPeA +1 more | ND / 7.1 ppt | Oct 2023 – Oct 2024 |
| Jordan Valley WCD serves over 10,000 people | None detected | — | Aug 2023 – May 2025 |
| Holliday Water Company serves over 10,000 people | None detected | — | Aug 2023 – Jul 2024 |
| Murray City Water System serves over 10,000 people | PFPeA, PFBS, PFHxA +4 more | 4 / ND ppt | Apr 2024 – Feb 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Millcreek
Millcreek is served by more than one water system. Their service line inventories, as reported to EPA:
Water systems serving Millcreek
| Water system | Service lines | Total |
|---|---|---|
| Salt Lake City Water System | 120 lead · 102 galvanized · 31,866 unknown | 86,123 |
| Jordan Valley WCD | 0 lead · 0 galvanized · 0 unknown | 8,578 |
| Holliday Water Company | 0 lead · 0 galvanized · 1,767 unknown | 4,003 |
| Murray City Water System | 0 lead · 17 galvanized · 291 unknown | 10,346 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Millcreek drinking water violations
Millcreek is served by more than one water system. Health-based violations recorded by EPA since 2016:
Water systems serving Millcreek
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Salt Lake City Water System | 1 | 4 |
| Jordan Valley WCD | None | 2 |
| Holliday Water Company | 2 | 3 |
| Murray City Water System | None | 8 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Millcreek
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| (D- 1- 1)33ddd- 1 USGS Utah Water Science Center | Well | 0.5 mi | 455 mg/L | 3 | 2001–2021 |
| MILL CREEK AT 2000 EAST, SLC, UT USGS Utah Water Science Center | Stream | 0.5 mi | 301 mg/L | 2 | 2000 |
| (D- 2- 1) 4acb- 1 USGS Utah Water Science Center | Well | 1.1 mi | 547 mg/L | 1 | 2001 |
| (D- 1- 1)35cda- 1 USGS Utah Water Science Center | Well | 1.3 mi | 394 mg/L | 2 | 2008–2021 |
| MILL CREEK AT 3060 EAST, SLC, UT USGS Utah Water Science Center | Stream | 1.4 mi | 300 mg/L | 2 | 2000 |
| BIG COTTONWOOD CK AT CREEKSIDE PARK (BC4.73) Utah Department Of Environmental Quality | River/Stream | 1.9 mi | 222 mg/L | 12 | 2011–2012 |
Water hardness in towns near Millcreek
| Town | Distance | Median | Class |
|---|---|---|---|
| Holladay | 2 mi | 351 mg/L | Very hard |
| South Salt Lake | 4 mi | 350 mg/L | Very hard |
| Murray | 4 mi | 356 mg/L | Very hard |
| Cottonwood Heights | 5 mi | 346 mg/L | Very hard |
| Midvale | 6 mi | 364 mg/L | Very hard |
| Taylorsville | 7 mi | 370 mg/L | Very hard |
| Salt Lake City | 8 mi | 363 mg/L | Very hard |
| Sandy | 8 mi | 349 mg/L | Very hard |
| West Valley City | 10 mi | 176 mg/L | Hard |
| Kearns metro township | 10 mi | 397 mg/L | Very hard |
Salt Lake County
Millcreek is in Salt Lake County, where the median is 369 mg/L (very hard) across 381 sites.
See all of Salt Lake County →Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.