Water hardness in Midvale, UT
Water in Midvale is very hard, with a median of 364 mg/L (21.2 grains per gallon) across 162 monitoring sites within 10 miles.
Midvale tap water at a glance
- HardnessVery hard (364 mg/L, 21.2 gpg, local measurements). Water softeners are common at this level.Size a water softener →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 364 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 21.2 gpg (20.4 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Midvale
Prefilled with Midvale's measured local hardness of 364 mg/L (21.3 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Midvale tap water
Midvale is served by more than one water system. These systems supply ZIP codes in Midvale and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.
Water systems serving Midvale
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Jordan Valley WCD serves over 10,000 people | None detected | — | Aug 2023 – May 2025 |
| Salt Lake City Water System serves over 10,000 people | PFHxS, PFOS, PFPeA +1 more | ND / 7.1 ppt | Oct 2023 – Oct 2024 |
| Sandy City Water System serves over 10,000 people | None detected | — | Jul 2023 – Jul 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Midvale
Midvale is served by more than one water system. Their service line inventories, as reported to EPA:
Water systems serving Midvale
| Water system | Service lines | Total |
|---|---|---|
| Jordan Valley WCD | 0 lead · 0 galvanized · 0 unknown | 8,578 |
| Salt Lake City Water System | 120 lead · 102 galvanized · 31,866 unknown | 86,123 |
| Sandy City Water System | 0 lead · 0 galvanized · 0 unknown | 26,213 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Midvale drinking water violations
Midvale is served by more than one water system. Health-based violations recorded by EPA since 2016:
Water systems serving Midvale
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Jordan Valley WCD | None | 2 |
| Salt Lake City Water System | 1 | 4 |
| Sandy City Water System | 1 | 133 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Midvale
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| (C- 2- 1)25cbb- 1 USGS Utah Water Science Center | Well | 0.8 mi | 211 mg/L | 2 | 2000–2001 |
| (C- 2 -1)36bac- 1 USGS Utah Water Science Center | Well | 0.8 mi | 243 mg/L | 3 | 2001–2021 |
| (C- 2- 1)23dad- 1 USGS Utah Water Science Center | Well | 1.4 mi | 245 mg/L | 3 | 2001–2021 |
| (D- 2- 1)20ccb- 2 USGS Utah Water Science Center | Well | 1.4 mi | 449 mg/L | 2 | 2012–2020 |
| (D- 2- 1)29acb- 2 USGS Utah Water Science Center | Well | 1.6 mi | 359 mg/L | 2 | 2000 |
| (D- 2- 1)29acb- 8 USGS Utah Water Science Center | Well | 1.6 mi | 81 mg/L | 2 | 2000–2008 |
Water hardness in towns near Midvale
| Town | Distance | Median | Class |
|---|---|---|---|
| Murray | 3 mi | 356 mg/L | Very hard |
| Sandy | 4 mi | 349 mg/L | Very hard |
| Cottonwood Heights | 4 mi | 346 mg/L | Very hard |
| Taylorsville | 4 mi | 370 mg/L | Very hard |
| Holladay | 5 mi | 351 mg/L | Very hard |
| West Jordan | 6 mi | 183 mg/L | Very hard |
| South Jordan | 6 mi | 404 mg/L | Very hard |
| Millcreek | 6 mi | 344 mg/L | Very hard |
| South Salt Lake | 6 mi | 350 mg/L | Very hard |
| Kearns metro township | 7 mi | 397 mg/L | Very hard |
Salt Lake County
Midvale is in Salt Lake County, where the median is 369 mg/L (very hard) across 381 sites.
See all of Salt Lake County →Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.