Water hardness in Blackford County, IN
Water in Blackford County is very hard, with a median of 290 mg/L (16.9 grains per gallon) across 9 monitoring sites.
Blackford County water at a glance
- HardnessVery hard (290 mg/L, 16.9 gpg, local measurements). Water softeners are common at this level.Size a water softener →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 290 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 16.9 gpg (16.2 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Blackford County
Prefilled with Blackford County's measured local hardness of 290 mg/L (17 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Blackford County on the Indiana map
Cities and communities in Blackford County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Hartford City | 303 | Very hard | 11 sites within 10 miles |
| Dunkirk | 290 | Very hard | 9 sites within 10 miles |
| Montpelier | 303 | Very hard | 11 sites within 10 miles |
| Shamrock Lakes | 296 | Very hard | 10 sites within 10 miles |
| Keystone (CDP) | 370 | Very hard | 5 sites within 10 miles |
| Millgrove (CDP) | 275 | Very hard | 8 sites within 10 miles |
| Roll (CDP) | 296 | Very hard | 10 sites within 10 miles |
Water quality in Blackford County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Hartford City | Hartford City Water Works | None detected | 2 lead · 1,789 unknown | None |
| Dunkirk | Dunkirk Water Department | Not tested | 0 lead · 0 unknown | None |
| Montpelier | Montpelier Water Works | Not tested | 0 lead · 524 unknown | None |
Neighboring counties
- Jay County399 mg/L
- Delaware County332 mg/L
- Grant County322 mg/L
- Wells County315 mg/L
- Huntington County308 mg/L
- Randolph County356 mg/L
Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.