Water hardness in Harker Heights, TX

Water in Harker Heights is very hard, with a median of 291 mg/L (17 grains per gallon) across 3 monitoring sites within 10 miles.

50% harder than the Texas median (194 mg/L) 45th hardest of 251 Texas towns Population 34,447
291mg/L
17 grains per gallon
Very hard

Harker Heights tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 291 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 17 gpg (16.3 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites3
Lab samples6
Sample years2012–2021
Middle 50% of sites255–292 mg/L
Groundwater (wells, springs)291 mg/L · 3 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Harker Heights

Prefilled with Harker Heights's measured local hardness of 291 mg/L (17 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Harker Heights tap water

City of Harker Heights is the main public water system for Harker Heights. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Mar 2023 – May 2024. 3 PFAS were detected. Every result with a federal limit was at or below it.

ChemicalHighest resultDetected inEPA limit
PFBA
perfluorobutanoic acid
8 ppt 4 of 4 samples —
PFHxS
perfluorohexane sulfonic acid
4.8 ppt 2 of 4 samples 10 ppt*
PFBS
perfluorobutane sulfonic acid
3.4 ppt 1 of 4 samples —

Other water systems serving parts of Harker Heights

Water systemPFAS detectedHighest PFOA / PFOSTested
City of Belton
serves over 10,000 people
PFBA, PFPeA, PFHxS +1 more — May 2023 – Mar 2024
City of Temple
serves over 10,000 people
PFBA, PFHxA, PFPeA +3 more ND / 4.9 ppt Jan 2023 – Mar 2024
City of Killeen
serves over 10,000 people
PFBA, PFPeA, PFBS — Mar 2025 – Dec 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Harker Heights

City of Harker Heights reported 12,878 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 105 are galvanized lines that must be replaced, and 2,852 are still of unknown material.

0lead (0%)
105galvanized requiring replacement
2,852unknown material (22%)
9,921not lead (77%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask City of Harker Heights whether your address is on its list.

Other water systems serving parts of Harker Heights

Water systemService linesTotal
City of Belton0 lead · 0 galvanized · 3,036 unknown8,842
City of Temple0 lead · 0 galvanized · 127 unknown24,402
City of Killeen0 lead · 2,426 galvanized · 0 unknown56,364

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Harker Heights drinking water violations

EPA records show no health-based violations for City of Harker Heights since 2016. It also had 1 monitoring or reporting violation (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Harker Heights

Water systemHealth-based violationsMonitoring/reporting
City of BeltonNone0
City of Temple223
City of KilleenNone2

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Harker Heights

SiteTypeDistanceMedianSamplesYears
AX-40-58-903 (CUWCD E-06-063P)
USGS Texas Water Science Center
Well 7.3 mi220 mg/L22021
AX-58-04-515
USGS Texas Water Science Center
Spring 9.9 mi292 mg/L32012–2015
Domestic well nr IH-35 and Salado Ck
USGS Texas Water Science Center
Well 9.9 mi291 mg/L12015

Water hardness in towns near Harker Heights

TownDistanceMedianClass
Killeen5 mi 220 mg/LVery hard
Belton10 mi 287 mg/LVery hard
Fort Hood10 mi 311 mg/LVery hard
Temple15 mi 285 mg/LVery hard
Copperas Cove17 mi 311 mg/LVery hard
Georgetown27 mi 326 mg/LVery hard
Gatesville27 mi 311 mg/LVery hard
Liberty Hill31 mi 322 mg/LVery hard
Leander36 mi 340 mg/LVery hard
Taylor36 mi 322 mg/LVery hard

Bell County

Harker Heights is in Bell County, where the median is 285 mg/L (very hard) across 18 sites.

See all of Bell County →

Texas

The statewide median is 194 mg/L (very hard) from 2,271 sites.

Texas hardness map →

Harker Heights, TX water: common questions

Do I need a water softener in Harker Heights?

Very likely. Water measured around Harker Heights is 17 gpg (291 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 30,000 grains.Size it for your household →

Who supplies Harker Heights's drinking water?

The main public water system serving Harker Heights in EPA records is City of Harker Heights. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Harker Heights?

It depends on what you want to remove. In Harker Heights, EPA testing found PFBA, PFHxS and PFBS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next