Water hardness in Fort Hood, TX

Water in Fort Hood is very hard, with a median of 311 mg/L (18.2 grains per gallon) across Coryell County.

60% harder than the Texas median (194 mg/L) 36th hardest of 251 Texas towns Population 29,589 (2010)
311mg/L
18.2 grains per gallon
Very hard

There are not enough monitoring sites within 10 miles of Fort Hood, so this page uses the Coryell County median.

Fort Hood tap water at a glance

  • HardnessVery hard (311 mg/L, 18.2 gpg, local measurements). Water softeners are common at this level.Size a water softener →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 311 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 18.2 gpg (17.4 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites1
Lab samples4
Sample years2005–2006
Middle 50% of sites311–311 mg/L
Surface water (rivers, lakes)311 mg/L · 1 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Fort Hood

Prefilled with Fort Hood's measured local hardness of 311 mg/L (18.2 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Fort Hood tap water

Fort Hood is served by more than one water system. These systems supply ZIP codes in Fort Hood and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Fort Hood

Water systemPFAS detectedHighest PFOA / PFOSTested
City of Killeen
serves over 10,000 people
PFBA, PFPeA, PFBS — Mar 2025 – Dec 2025
US ARMY South Fort Hood
serves over 10,000 people
PFBA, PFHxS, PFPeA +1 more — Nov 2023 – Aug 2024
Kempner WSC
serves over 10,000 people
PFBA, PFBS, PFPeA — May 2024 – May 2025
City of Georgetown
serves over 10,000 people
PFBA, PFPeA, PFHxA +4 more 4.9 / 5.7 ppt Jun 2023 – Feb 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Fort Hood

Fort Hood is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Fort Hood

Water systemService linesTotal
City of Killeen0 lead · 2,426 galvanized · 0 unknown56,364
US ARMY South Fort Cavazos0 lead · 0 galvanized · 0 unknown7,041
Kempner WSC0 lead · 0 galvanized · 0 unknown5,797
City of Georgetown0 lead · 161 galvanized · 4 unknown62,099

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Fort Hood drinking water violations

Fort Hood is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Fort Hood

Water systemHealth-based violationsMonitoring/reporting
City of KilleenNone2
US ARMY South Fort HoodNone0
Kempner WSC93
City of Georgetown12

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Fort Hood

SiteTypeDistanceMedianSamplesYears
AX-40-58-201
USGS Texas Water Science Center
Well 2.7 mi640 mg/L12015
AX-40-58-903 (CUWCD E-06-063P)
USGS Texas Water Science Center
Well 7.7 mi220 mg/L22021

Water hardness in towns near Fort Hood

TownDistanceMedianClass
Killeen5 mi 220 mg/LVery hard
Copperas Cove8 mi 311 mg/LVery hard
Harker Heights10 mi 291 mg/LVery hard
Belton19 mi 287 mg/LVery hard
Gatesville21 mi 311 mg/LVery hard
Temple23 mi 285 mg/LVery hard
Georgetown33 mi 326 mg/LVery hard
Liberty Hill33 mi 322 mg/LVery hard
Leander39 mi 340 mg/LVery hard
Hewitt41 mi 150 mg/LHard

Coryell County

Fort Hood is in Coryell County, where the median is 311 mg/L (very hard) across 1 sites.

See all of Coryell County →

Texas

The statewide median is 194 mg/L (very hard) from 2,271 sites.

Texas hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next