Water hardness in Belton, TX

Water in Belton is very hard, with a median of 287 mg/L (16.8 grains per gallon) across 12 monitoring sites within 10 miles.

48% harder than the Texas median (194 mg/L) 48th hardest of 251 Texas towns Population 25,171
287mg/L
16.8 grains per gallon
Very hard

Belton tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 287 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 16.8 gpg (16.1 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites12
Lab samples36
Sample years2012–2022
Middle 50% of sites281–291 mg/L
Groundwater (wells, springs)289 mg/L · 11 sites
Surface water (rivers, lakes)240 mg/L · 1 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Belton

Prefilled with Belton's measured local hardness of 287 mg/L (16.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Belton tap water

City of Belton is the main public water system for Belton. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken May 2023 – Mar 2024. 4 PFAS were detected. Every result with a federal limit was at or below it.

ChemicalHighest resultDetected inEPA limit
PFBA
perfluorobutanoic acid
9.8 ppt 3 of 4 samples —
PFPeA
perfluoropentanoic acid
3.8 ppt 2 of 4 samples —
PFHxS
perfluorohexane sulfonic acid
3.7 ppt 3 of 4 samples 10 ppt*
PFBS
perfluorobutane sulfonic acid
3.4 ppt 1 of 4 samples —

Other water systems serving parts of Belton

Water systemPFAS detectedHighest PFOA / PFOSTested
City of Temple
serves over 10,000 people
PFBA, PFHxA, PFPeA +3 more ND / 4.9 ppt Jan 2023 – Mar 2024
Kempner WSC
serves over 10,000 people
PFBA, PFBS, PFPeA — May 2024 – May 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Belton

City of Belton reported 8,842 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 3,036 lines are still of unknown material.

0lead (0%)
0galvanized requiring replacement
3,036unknown material (34%)
5,806not lead (66%)

Other water systems serving parts of Belton

Water systemService linesTotal
City of Temple0 lead · 0 galvanized · 127 unknown24,402
Kempner WSC0 lead · 0 galvanized · 0 unknown5,797

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Belton drinking water violations

EPA records show no health-based violations for City of Belton since 2016.

Other water systems serving parts of Belton

Water systemHealth-based violationsMonitoring/reporting
City of Temple223
Kempner WSC93

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Belton

SiteTypeDistanceMedianSamplesYears
AX-58-04-6xx
USGS Texas Water Science Center
Spring 8.1 mi282 mg/L22012–2015
Salado Ck at Salado, TX
USGS Texas Water Science Center
Stream 8.1 mi240 mg/L32013–2014
AX-58-04-614
USGS Texas Water Science Center
Spring 8.1 mi280 mg/L22012–2015
AX-58-04-630
USGS Texas Water Science Center
Spring 8.2 mi290 mg/L22012–2015
AX-58-04-613
USGS Texas Water Science Center
Spring 8.3 mi285 mg/L22012–2015
AX-58-04-629
USGS Texas Water Science Center
Spring 8.3 mi286 mg/L122012–2015

Water hardness in towns near Belton

TownDistanceMedianClass
Temple6 mi 285 mg/LVery hard
Harker Heights10 mi 291 mg/LVery hard
Killeen15 mi 220 mg/LVery hard
Fort Hood19 mi 311 mg/LVery hard
Copperas Cove26 mi 311 mg/LVery hard
Georgetown30 mi 326 mg/LVery hard
Gatesville31 mi 311 mg/LVery hard
Hewitt32 mi 150 mg/LHard
Taylor33 mi 322 mg/LVery hard
Robinson35 mi 150 mg/LHard

Bell County

Belton is in Bell County, where the median is 285 mg/L (very hard) across 18 sites.

See all of Bell County →

Texas

The statewide median is 194 mg/L (very hard) from 2,271 sites.

Texas hardness map →

Belton, TX water: common questions

Do I need a water softener in Belton?

Very likely. Water measured around Belton is 16.8 gpg (287 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 29,000 grains.Size it for your household →

Who supplies Belton's drinking water?

The main public water system serving Belton in EPA records is City of Belton. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Belton?

It depends on what you want to remove. In Belton, EPA testing found PFBA, PFPeA and PFHxS and 1 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next