Water hardness in Sand Springs, OK

Water in Sand Springs is hard, with a median of 152 mg/L (8.9 grains per gallon) across Tulsa County.

34% softer than the Oklahoma median (231 mg/L) 37th hardest of 45 Oklahoma towns Population 20,075
152mg/L
8.9 grains per gallon
Hard

There are not enough monitoring sites within 10 miles of Sand Springs, so this page uses the Tulsa County median.

Sand Springs tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 152 mg/L means at home

  • Water softener: Many households here choose a softener to protect water heaters and appliances from scale.
  • Dishwasher: set the water hardness to about 8.9 gpg (8.5 °dH), which is a medium-to-high hardness setting, with rinse aid.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites7
Lab samples235
Sample years2006–2025
Middle 50% of sites135–181 mg/L
Surface water (rivers, lakes)152 mg/L · 7 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Sand Springs

Prefilled with Sand Springs's measured local hardness of 152 mg/L (8.9 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Sand Springs tap water

The City of Sand Springs water system is the main public water system for Sand Springs. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Aug 2023 – May 2024. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Sand Springs

Water systemPFAS detectedHighest PFOA / PFOSTested
Tulsa
serves over 10,000 people
None detected — Jan 2023 – Oct 2023
Washington Co RWD #3 (New,#1)
serves over 10,000 people
None detected — Dec 2024 – Sep 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Sand Springs

The City of Sand Springs water system reported 13,837 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 134 are galvanized lines that must be replaced, and 11,918 are still of unknown material.

0lead (0%)
134galvanized requiring replacement
11,918unknown material (86%)
1,785not lead (13%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask the City of Sand Springs water system whether your address is on its list.

Other water systems serving parts of Sand Springs

Water systemService linesTotal
Tulsa0 lead · 0 galvanized · 128,216 unknown162,343
Washington Co RWD #3 (New,#1)0 lead · 0 galvanized · 2,651 unknown11,862

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Sand Springs drinking water violations

EPA records show no health-based violations for the City of Sand Springs water system since 2016. It also had 6 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Sand Springs

Water systemHealth-based violationsMonitoring/reporting
TulsaNone23
Washington Co RWD #3 (New,#1)None4

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Sand Springs

SiteTypeDistanceMedianSamplesYears
Rock Creek
Oklahoma Conservation Commission (State)
River/Stream 9.7 mi70 mg/L12009
Rock Creek
Oklahoma Conservation Commission (State)
River/Stream 9.7 mi70 mg/L12009

Water hardness in towns near Sand Springs

TownDistanceMedianClass
Sapulpa9 mi 207 mg/LVery hard
Tulsa13 mi 152 mg/LHard
Jenks13 mi 207 mg/LVery hard
Glenpool15 mi 207 mg/LVery hard
Bixby19 mi 212 mg/LVery hard
Owasso20 mi 126 mg/LHard
Broken Arrow21 mi 152 mg/LHard
Coweta28 mi 112 mg/LModerately hard
Claremore32 mi 120 mg/LModerately hard
Okmulgee37 mi 152 mg/LHard

Tulsa County

Sand Springs is in Tulsa County, where the median is 152 mg/L (hard) across 7 sites.

See all of Tulsa County →

Oklahoma

The statewide median is 231 mg/L (very hard) from 1,773 sites.

Oklahoma hardness map →

Sand Springs, OK water: common questions

Do I need a water softener in Sand Springs?

Many homes here use one. Water measured around Sand Springs is 8.9 gpg (152 mg/L, measured locally), above the 7 gpg (120 mg/L) level where scale on fixtures, appliances and water heaters becomes noticeable. For a 3-person home that regenerates weekly, that means a softener of about 16,000 grains.Size it for your household →

Who supplies Sand Springs's drinking water?

The main public water system serving Sand Springs in EPA records is Sand Springs. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Sand Springs?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next