Water hardness in Campbellsville, KY

Water in Campbellsville is moderately hard, with a median of 86 mg/L (5.1 grains per gallon) across Taylor County.

33% softer than the Kentucky median (128 mg/L) 33rd hardest of 35 Kentucky towns Population 11,653
86mg/L
5.1 grains per gallon
Moderately hard

There are not enough monitoring sites within 10 miles of Campbellsville, so this page uses the Taylor County median.

Campbellsville tap water at a glance

  • HardnessModerately hard (86 mg/L, 5.1 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 86 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 5.1 gpg (4.8 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites2
Lab samples6
Sample years2006–2006
Middle 50% of sites85–88 mg/L
Surface water (rivers, lakes)86 mg/L · 2 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Campbellsville

Prefilled with Campbellsville's measured local hardness of 86 mg/L (5 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Campbellsville tap water

Campbellsville Municipal Water is the main public water system for Campbellsville. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Mar 2024 – Dec 2024. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Campbellsville

Water systemPFAS detectedHighest PFOA / PFOSTested
Columbia/Adair Utilities District
serves over 10,000 people
None detected — Mar 2024 – Dec 2024
Marion County Water District
serves over 10,000 people
None detected — Mar 2024 – Dec 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Campbellsville

Campbellsville Municipal Water reported 11,919 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
11,919not lead (100%)

Other water systems serving parts of Campbellsville

Water systemService linesTotal
Columbia/Adair Utilities District0 lead · 8 galvanized · 9,258 unknown10,369
Marion County Water District0 lead · 0 galvanized · 0 unknown7,404

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Campbellsville drinking water violations

EPA records show no health-based violations for Campbellsville Municipal Water since 2016. It also had 3 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Campbellsville

Water systemHealth-based violationsMonitoring/reporting
Columbia/Adair Utilities District18
Marion County Water DistrictNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Campbellsville

SiteTypeDistanceMedianSamplesYears
CAMPBELLSVILLE CITY LAKE NEAR CAMPBELLSVILLE
Kentucky Division of Water
Lake 1.1 mi83 mg/L32006
SPURLINGTON LAKE NEAR SPURLINGTON
Kentucky Division of Water
Lake 6 mi90 mg/L32006

Water hardness in towns near Campbellsville

TownDistanceMedianClass
Bardstown33 mi 203 mg/LVery hard
Elizabethtown38 mi 204 mg/LVery hard
Glasgow39 mi 192 mg/LVery hard
Somerset45 mi 98 mg/LModerately hard
Radcliff46 mi 204 mg/LVery hard
Shepherdsville48 mi 221 mg/LVery hard
Mount Washington50 mi 231 mg/LVery hard
Fort Knox51 mi 358 mg/LVery hard
Lawrenceburg54 mi 178 mg/LHard
Louisville/Jefferson County metro government59 mi 135 mg/LHard

Taylor County

Campbellsville is in Taylor County, where the median is 86 mg/L (moderately hard) across 2 sites.

See all of Taylor County →

Kentucky

The statewide median is 128 mg/L (hard) from 372 sites.

Kentucky hardness map →

Campbellsville, KY water: common questions

Do I need a water softener in Campbellsville?

Probably not. Water measured around Campbellsville is 5.1 gpg (86 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 9,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Campbellsville's drinking water?

The main public water system serving Campbellsville in EPA records is Campbellsville Municipal Water. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Campbellsville?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next