Water hardness in Mount Washington, KY
Water in Mount Washington is very hard, with a median of 231 mg/L (13.5 grains per gallon) across 3 monitoring sites within 10 miles.
Mount Washington tap water at a glance
- HardnessVery hard (231 mg/L, 13.5 gpg, local measurements). Water softeners are common at this level.Size a water softener →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 231 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 13.5 gpg (12.9 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Mount Washington
Prefilled with Mount Washington's measured local hardness of 231 mg/L (13.5 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Mount Washington tap water
Mount Washington is served by more than one water system. These systems supply ZIP codes in Mount Washington and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.
Water systems serving Mount Washington
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| MT Washington Water Company serves over 10,000 people | PFOA, PFPeA | 7.2 / ND ppt | Jun 2025 – Feb 2026 |
| Louisville Water Company serves over 10,000 people | PFOA, PFPeA, PFHxA +1 more | 7.5 / ND ppt | Feb 2023 – Nov 2023 |
| North Nelson Water District serves over 10,000 people | PFOA, PFPeA, PFBS | 5.7 / ND ppt | Jan 2023 – Oct 2023 |
| Taylorsville Water Works serves over 10,000 people | PFOA, PFPeA | 6.5 / ND ppt | May 2025 – Feb 2026 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Mount Washington
Mount Washington is served by more than one water system. Their service line inventories, as reported to EPA:
Water systems serving Mount Washington
| Water system | Service lines | Total |
|---|---|---|
| MT Washington Water Company | 0 lead · 0 galvanized · 3,408 unknown | 11,322 |
| Louisville Water Company | 483 lead · 2,064 galvanized · 59,521 unknown | 327,653 |
| North Nelson Water District | 0 lead · 0 galvanized · 0 unknown | 5,301 |
| Taylorsville Water Works | 55 lead · 85 galvanized · 684 unknown | 9,192 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Mount Washington drinking water violations
Mount Washington is served by more than one water system. Health-based violations recorded by EPA since 2016:
Water systems serving Mount Washington
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| MT Washington Water Company | None | 5 |
| Louisville Water Company | None | 0 |
| North Nelson Water District | None | 0 |
| Taylorsville Water Works | None | 1 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Mount Washington
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| COX CREEK NEAR SOLITUDE Kentucky Division of Water | River/Stream | 4.8 mi | 231 mg/L | 11 | 2004–2005 |
| FLOYDS FORK NEAR SHEPHERDSVILLE Kentucky Division of Water | River/Stream | 5.7 mi | 235 mg/L | 51 | 2000–2007 |
| SALT RIVER AT SHEPHERDSVILLE Kentucky Division of Water | River/Stream | 9.6 mi | 193 mg/L | 53 | 2000–2007 |
Water hardness in towns near Mount Washington
| Town | Distance | Median | Class |
|---|---|---|---|
| Shepherdsville | 9 mi | 221 mg/L | Very hard |
| Louisville/Jefferson County metro government | 10 mi | 135 mg/L | Hard |
| Jeffersontown | 11 mi | 408 mg/L | Very hard |
| St. Matthews | 15 mi | 441 mg/L | Very hard |
| Lyndon | 15 mi | 256 mg/L | Very hard |
| Bardstown | 16 mi | 203 mg/L | Very hard |
| Shively | 18 mi | 467 mg/L | Very hard |
| Shelbyville | 21 mi | 198 mg/L | Very hard |
| Fort Knox | 25 mi | 358 mg/L | Very hard |
| Radcliff | 26 mi | 204 mg/L | Very hard |
Bullitt County
Mount Washington is in Bullitt County, where the median is 211 mg/L (very hard) across 5 sites.
See all of Bullitt County →Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.