Water hardness in Washington, IN

Water in Washington is hard, with a median of 147 mg/L (8.6 grains per gallon) across 14 monitoring sites within 10 miles.

51% softer than the Indiana median (303 mg/L) 83rd hardest of 86 Indiana towns Population 12,513
147mg/L
8.6 grains per gallon
Hard

Washington tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 147 mg/L means at home

  • Water softener: Many households here choose a softener to protect water heaters and appliances from scale.
  • Dishwasher: set the water hardness to about 8.6 gpg (8.2 °dH), which is a medium-to-high hardness setting, with rinse aid.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites14
Lab samples75
Sample years2000–2004
Middle 50% of sites131–182 mg/L
Surface water (rivers, lakes)147 mg/L · 14 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Washington

Prefilled with Washington's measured local hardness of 147 mg/L (8.6 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Washington tap water

Washington Water Works is the main public water system for Washington. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 2 samples taken Mar 2023 – Nov 2023. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Washington

Water systemPFAS detectedHighest PFOA / PFOSTested
Daviess County Rural Water
serves 10,000 people or fewer
None detected — Mar 2023 – Sep 2023

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Washington

Washington Water Works reported 5,821 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 5,176 lines are still of unknown material.

0lead (0%)
0galvanized requiring replacement
5,176unknown material (89%)
645not lead (11%)

Other water systems serving parts of Washington

Water systemService linesTotal
Daviess County Rural Water0 lead · 4 galvanized · 1,944 unknown3,397

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Washington drinking water violations

EPA records show 1 health-based violation for Washington Water Works since 2016, all since resolved or closed. The most recent began in Sep 2025. It also had 2 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Contaminant or ruleTypeViolationsMost recentStatus
Disinfection byproducts rule
requirements to limit chlorine byproducts
Treatment requirement not met 1 Sep 2025 Resolved/closed

Other water systems serving parts of Washington

Water systemHealth-based violationsMonitoring/reporting
Daviess County Rural WaterNone1

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Washington

SiteTypeDistanceMedianSamplesYears
WWL080-0005
Indiana STORET
River/Stream 4 mi170 mg/L32001
WWL090-0006
Indiana STORET
River/Stream 4.2 mi238 mg/L32001
WWL080-0006
Indiana STORET
River/Stream 4.6 mi251 mg/L32001
WWL090-0025
Indiana STORET
River/Stream 8.1 mi186 mg/L12001
WWL090-0026
Indiana STORET
River/Stream 8.3 mi142 mg/L22001
WWL090-0003
Indiana STORET
River/Stream 8.5 mi126 mg/L12001

Water hardness in towns near Washington

TownDistanceMedianClass
Vincennes19 mi 238 mg/LVery hard
Jasper22 mi 124 mg/LHard
Bedford39 mi 224 mg/LVery hard
Bloomington49 mi 302 mg/LVery hard
Terre Haute57 mi 186 mg/LVery hard
Martinsville65 mi 297 mg/LVery hard
Seymour71 mi 220 mg/LVery hard
New Albany76 mi 220 mg/LVery hard
Columbus77 mi 192 mg/LVery hard
Sellersburg77 mi 125 mg/LHard

Daviess County

Washington is in Daviess County, where the median is 244 mg/L (very hard) across 6 sites.

See all of Daviess County →

Indiana

The statewide median is 303 mg/L (very hard) from 1,344 sites.

Indiana hardness map →

Washington, IN water: common questions

Do I need a water softener in Washington?

Many homes here use one. Water measured around Washington is 8.6 gpg (147 mg/L, measured locally), above the 7 gpg (120 mg/L) level where scale on fixtures, appliances and water heaters becomes noticeable. For a 3-person home that regenerates weekly, that means a softener of about 15,000 grains.Size it for your household →

Who supplies Washington's drinking water?

The main public water system serving Washington in EPA records is Washington Water Works. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Washington?

It depends on what you want to remove. In Washington, the system had 1 health-based violation since 2016, for the Stage 1 Disinfectants and Disinfection Byproducts Rule; the utility's annual report says what was done about it. On the other hand, no PFAS found in EPA testing and no lead service lines reported. A water softener is not a filter.How to read your water quality report →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next