Water hardness in Culver City, CA
Water in Culver City is very hard, with a median of 240 mg/L (14 grains per gallon) across 79 monitoring sites within 10 miles.
Culver City tap water at a glance
- HardnessVery hard (240 mg/L, 14 gpg, local measurements). Water softeners are common at this level.Size a water softener →
- PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
- Lead pipesNo lead service lines reported.Details →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 240 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 14 gpg (13.4 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Culver City
Prefilled with Culver City's measured local hardness of 240 mg/L (14 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Culver City tap water
GSWC - Culver City is the main public water system for Culver City. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Nov 2023 – Aug 2024. No PFAS were found at or above EPA's minimum reporting levels.
Other water systems serving parts of Culver City
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Los Angeles-City, Dept. of Water & Power serves over 10,000 people | None detected | — | Dec 2023 – Sep 2024 |
| Hawthorne-City Water Dept. serves over 10,000 people | None detected | — | Jun 2023 – Mar 2024 |
| GSWC - Southwest serves over 10,000 people | None detected | — | Jun 2024 – Mar 2025 |
| Los Angeles CWWD 29 & 80-Malibu serves over 10,000 people | None detected | — | May 2024 – Feb 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Culver City
GSWC - Culver City reported 9,529 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.
Other water systems serving parts of Culver City
| Water system | Service lines | Total |
|---|---|---|
| Los Angeles-City, Dept. of Water & Power | 0 lead · 0 galvanized · 0 unknown | 744,960 |
| Hawthorne-City Water Dept. | 0 lead · 0 galvanized · 0 unknown | 6,553 |
| GSWC - Southwest | 0 lead · 0 galvanized · 0 unknown | 53,883 |
| Los Angeles CWWD 29 & 80-Malibu | 0 lead · 0 galvanized · 0 unknown | 9,338 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Culver City drinking water violations
EPA records show no health-based violations for GSWC - Culver City since 2016.
Other water systems serving parts of Culver City
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Los Angeles-City, Dept. of Water & Power | 2 | 2 |
| Hawthorne-City Water Dept. | None | 2 |
| GSWC - Southwest | None | 0 |
| Los Angeles CWWD 29 & 80-Malibu | None | 0 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Culver City
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| 002S014W18J001S USGS California Water Science Center | Well | 1.3 mi | 1080 mg/L | 1 | 2006 |
| 002S014W19G001S USGS California Water Science Center | Well | 1.7 mi | 269 mg/L | 2 | 2006–2016 |
| 002S015W11C21S USGS California Water Science Center | Well | 1.8 mi | 661 mg/L | 1 | 2020 |
| 002S015W11C019S USGS California Water Science Center | Well | 1.8 mi | 605 mg/L | 1 | 2020 |
| 002S014W04K001S USGS California Water Science Center | Well | 2.9 mi | 302 mg/L | 1 | 2018 |
| 002S014W04K006S USGS California Water Science Center | Well | 2.9 mi | 245 mg/L | 1 | 2018 |
Water hardness in towns near Culver City
| Town | Distance | Median | Class |
|---|---|---|---|
| Los Angeles | 1 mi | 170 mg/L | Hard |
| View Park-Windsor Hills | 3 mi | 207 mg/L | Very hard |
| Inglewood | 5 mi | 200 mg/L | Very hard |
| Beverly Hills | 5 mi | 285 mg/L | Very hard |
| Lennox | 5 mi | 198 mg/L | Very hard |
| Santa Monica | 6 mi | 338 mg/L | Very hard |
| West Hollywood | 6 mi | 302 mg/L | Very hard |
| Del Aire | 6 mi | 187 mg/L | Very hard |
| El Segundo | 7 mi | 209 mg/L | Very hard |
| Hawthorne | 7 mi | 184 mg/L | Very hard |
Los Angeles County
Culver City is in Los Angeles County, where the median is 200 mg/L (very hard) across 552 sites.
See all of Los Angeles County →Culver City, CA water: common questions
Do I need a water softener in Culver City?
Very likely. Water measured around Culver City is 14 gpg (240 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 25,000 grains.Size it for your household →
Who supplies Culver City's drinking water?
The main public water system serving Culver City in EPA records is GSWC - Culver City. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Culver City?
Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →
Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.