Water hardness in Sammamish, WA
Water in Sammamish is moderately hard, with a median of 70 mg/L (4.1 grains per gallon) across 11 monitoring sites within 10 miles.
Sammamish tap water at a glance
- HardnessModerately hard (70 mg/L, 4.1 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- PFAS6 found; the highest PFHxS and PFOS result was above EPA's 4 ppt limit (a single result is not a violation).Filters that remove PFAS →
- Lead pipesNo known lead lines; 17,213 lines are still of unknown material.Check your own pipe →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 70 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 4.1 gpg (3.9 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Sammamish
Prefilled with Sammamish's measured local hardness of 70 mg/L (4.1 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Sammamish tap water
Sammamish Plateau Water & Sewer is the main public water system for Sammamish. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 16 samples taken May 2023 – Feb 2024. 6 PFAS were detected. The highest PFHxS and PFOS results were above EPA's drinking water limit (10 ppt / 4 ppt).
| Chemical | Highest result | Detected in | EPA limit |
|---|---|---|---|
| PFHxS perfluorohexane sulfonic acid | 16.5 ppt | 9 of 16 samples | 10 ppt* |
| PFOS perfluorooctane sulfonic acid | 11.1 ppt | 4 of 16 samples | 4 ppt |
| PFBS perfluorobutane sulfonic acid | 8.8 ppt | 6 of 16 samples | — |
| PFHxA perfluorohexanoic acid | 4.3 ppt | 2 of 16 samples | — |
| PFPeS perfluoropentane sulfonic acid | 4.1 ppt | 1 of 16 samples | — |
| PFPeA perfluoropentanoic acid | 3.9 ppt | 2 of 16 samples | — |
Other water systems serving parts of Sammamish
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Issaquah Water System serves over 10,000 people | None detected | — | Sep 2024 – Jun 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Sammamish
Sammamish Plateau Water & Sewer reported 36,913 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 17,213 lines are still of unknown material.
Other water systems serving parts of Sammamish
| Water system | Service lines | Total |
|---|---|---|
| Issaquah Water System | 0 lead · 0 galvanized · 0 unknown | 9,402 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Sammamish drinking water violations
EPA records show no health-based violations for Sammamish Plateau Water & Sewer since 2016.
Other water systems serving parts of Sammamish
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Issaquah Water System | None | 0 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Sammamish
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| NORTH FORK ISSAQUAH CREEK AT ISSAQUAH, WA USGS Washington Water Science Center | Stream | 3.5 mi | 82 mg/L | 10 | 2015 |
| PATTERSON CREEK ABV CANYON CREEK NR FALL CITY, WA USGS Washington Water Science Center | Stream | 4.2 mi | 71 mg/L | 10 | 2015 |
| E FORK ISSAQUAH CR ABV 3RD AVE NE AT ISSAQUAH, WA USGS Washington Water Science Center | Stream | 4.3 mi | 45 mg/L | 10 | 2015 |
| BEAR CREEK AT UNION HILL RD AT REDMOND, WA USGS Washington Water Science Center | Stream | 6.5 mi | 65 mg/L | 10 | 2015 |
| MERCER CREEK NEAR BELLEVUE, WA USGS Washington Water Science Center | Stream | 6.7 mi | 110 mg/L | 10 | 2015 |
| COAL CREEK AT BELLEVUE, WA USGS Washington Water Science Center | Stream | 7 mi | 162 mg/L | 10 | 2015 |
Water hardness in towns near Sammamish
| Town | Distance | Median | Class |
|---|---|---|---|
| Issaquah | 3 mi | 65 mg/L | Moderately hard |
| Bellevue | 6 mi | 71 mg/L | Moderately hard |
| Union Hill-Novelty Hill | 6 mi | 70 mg/L | Moderately hard |
| Redmond | 7 mi | 73 mg/L | Moderately hard |
| Newcastle | 7 mi | 65 mg/L | Moderately hard |
| East Renton Highlands | 9 mi | 52 mg/L | Soft |
| Snoqualmie | 9 mi | 45 mg/L | Soft |
| Mercer Island | 9 mi | 80 mg/L | Moderately hard |
| Kirkland | 10 mi | 93 mg/L | Moderately hard |
| Cottage Lake | 11 mi | 66 mg/L | Moderately hard |
King County
Sammamish is in King County, where the median is 61 mg/L (moderately hard) across 34 sites.
See all of King County →Washington
The statewide median is 74 mg/L (moderately hard) from 890 sites.
Washington hardness map →Sammamish, WA water: common questions
Do I need a water softener in Sammamish?
Probably not. Water measured around Sammamish is 4.1 gpg (70 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 8,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →
Who supplies Sammamish's drinking water?
The main public water system serving Sammamish in EPA records is Sammamish Plateau Water & Sewer. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Sammamish?
It depends on what you want to remove. In Sammamish, EPA testing found PFHxS, PFOS and PFBS and 3 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →
Hardness scale
What to read next
- Which water filters remove PFAS?EPA tests found 6 PFAS in Sammamish's main water system.
- How to tell if your home has a lead pipe17,213 service lines here are of unknown material.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.