Water hardness in Kirkland, WA

Water in Kirkland is moderately hard, with a median of 93 mg/L (5.4 grains per gallon) across 9 monitoring sites within 10 miles.

26% harder than the Washington median (74 mg/L) 18th hardest of 122 Washington towns Population 91,194
93mg/L
5.4 grains per gallon
Moderately hard

Kirkland tap water at a glance

  • HardnessModerately hard (93 mg/L, 5.4 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 93 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 5.4 gpg (5.2 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites9
Lab samples99
Sample years2001–2015
Middle 50% of sites75–110 mg/L
Surface water (rivers, lakes)93 mg/L · 9 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Kirkland

Prefilled with Kirkland's measured local hardness of 93 mg/L (5.4 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Kirkland tap water

City of Kirkland is the main public water system for Kirkland. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Sep 2024 – Jun 2025. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Kirkland

Water systemPFAS detectedHighest PFOA / PFOSTested
Woodinville Water District
serves over 10,000 people
None detected — Sep 2024 – Jun 2025
Cross Valley Water District
serves over 10,000 people
PFBS, PFHxA, PFPeA — May 2024 – Feb 2025
Northshore Utility District
serves over 10,000 people
None detected — Mar 2023 – Dec 2023
City of Redmond Water System
serves over 10,000 people
PFOS, PFBS ND / 5 ppt Nov 2023 – Aug 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Kirkland

City of Kirkland reported 13,332 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 82 are galvanized lines that must be replaced.

0lead (0%)
82galvanized requiring replacement
0unknown material (0%)
13,250not lead (99%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask City of Kirkland whether your address is on its list.

Other water systems serving parts of Kirkland

Water systemService linesTotal
Woodinville Water District0 lead · 0 galvanized · 0 unknown14,831
Cross Valley Water District0 lead · 0 galvanized · 0 unknown7,179
Northshore Utility District0 lead · 0 galvanized · 2,001 unknown22,883
City of Redmond Water System0 lead · 0 galvanized · 0 unknown18,652

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Kirkland drinking water violations

EPA records show no health-based violations for City of Kirkland since 2016.

Other water systems serving parts of Kirkland

Water systemHealth-based violationsMonitoring/reporting
Woodinville Water DistrictNone0
Cross Valley Water DistrictNone3
Northshore Utility DistrictNone0
City of Redmond Water SystemNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Kirkland

SiteTypeDistanceMedianSamplesYears
JUANITA CREEK NEAR KIRKLAND, WA
USGS Washington Water Science Center
Stream 0.9 mi93 mg/L102015
THORNTON CREEK NEAR SEATTLE, WA
USGS Washington Water Science Center
Stream 3.4 mi103 mg/L192001–2015
BEAR CREEK AT WOODINVILLE, WA
USGS Washington Water Science Center
Stream 4.5 mi75 mg/L102015
BEAR CREEK AT UNION HILL RD AT REDMOND, WA
USGS Washington Water Science Center
Stream 4.7 mi65 mg/L102015
COTTAGE LAKE CREEK AB BEAR CREEK NEAR REDMOND, WA
USGS Washington Water Science Center
Stream 5.7 mi70 mg/L102015
MERCER CREEK NEAR BELLEVUE, WA
USGS Washington Water Science Center
Stream 6.6 mi110 mg/L102015

Water hardness in towns near Kirkland

TownDistanceMedianClass
Kenmore4 mi 91 mg/LModerately hard
Redmond4 mi 73 mg/LModerately hard
Woodinville5 mi 70 mg/LModerately hard
Bothell5 mi 88 mg/LModerately hard
Lake Forest Park6 mi 93 mg/LModerately hard
Cottage Lake7 mi 66 mg/LModerately hard
Bellevue7 mi 71 mg/LModerately hard
Bothell West8 mi 91 mg/LModerately hard
Shoreline8 mi 98 mg/LModerately hard
Mountlake Terrace8 mi 98 mg/LModerately hard

King County

Kirkland is in King County, where the median is 61 mg/L (moderately hard) across 34 sites.

See all of King County →

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Kirkland, WA water: common questions

Do I need a water softener in Kirkland?

Probably not. Water measured around Kirkland is 5.4 gpg (93 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 10,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Kirkland's drinking water?

The main public water system serving Kirkland in EPA records is City of Kirkland. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Kirkland?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next