Water hardness in Prairie Ridge, WA
Water in Prairie Ridge is soft, with a median of 54 mg/L (3.1 grains per gallon) across 11 monitoring sites within 10 miles.
Prairie Ridge tap water at a glance
- HardnessSoft (54 mg/L, 3.1 gpg, local measurements). A water softener isn't needed.Water heater care →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 54 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 3.1 gpg (3 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Prairie Ridge
Prefilled with Prairie Ridge's measured local hardness of 54 mg/L (3.2 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Prairie Ridge tap water
Prairie Ridge is served by more than one water system. These systems supply ZIP codes in Prairie Ridge and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.
Water systems serving Prairie Ridge
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| City of Tacoma Water Division serves over 10,000 people | PFHxS, PFBS | — | Jan 2025 – Oct 2025 |
| Bonney Lake Water Department City serves over 10,000 people | PFBS | — | May 2024 – Feb 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Prairie Ridge
Prairie Ridge is served by more than one water system. Their service line inventories, as reported to EPA:
Water systems serving Prairie Ridge
| Water system | Service lines | Total |
|---|---|---|
| City of Tacoma Water Division | 0 lead · 0 galvanized · 0 unknown | 114,107 |
| Bonney Lake Water Department City | 0 lead · 0 galvanized · 17 unknown | 22,128 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Prairie Ridge drinking water violations
Prairie Ridge is served by more than one water system. Health-based violations recorded by EPA since 2016:
Water systems serving Prairie Ridge
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| City of Tacoma Water Division | None | 0 |
| Bonney Lake Water Department City | None | 4 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Prairie Ridge
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| 20N/04E-36P02 UR-35B USGS Washington Water Science Center | Well | 5.1 mi | 127 mg/L | 9 | 2000–2012 |
| Upper Site 0050 Muckleshoot Indian Tribe (Tribal) | River/Stream | 5.8 mi | 93 mg/L | 21 | 2014–2017 |
| 19N/04E-02F02 UR-34 USGS Washington Water Science Center | Well | 5.9 mi | 33 mg/L | 1 | 2005 |
| 18N/05E-09H04 SU-021 USGS Washington Water Science Center | Well | 6 mi | 32 mg/L | 1 | 2016 |
| Mouth Site 0048 Muckleshoot Indian Tribe (Tribal) | River/Stream | 6.2 mi | 61 mg/L | 21 | 2014–2017 |
| 19N/04E-22A01 UR-29A USGS Washington Water Science Center | Well | 6.5 mi | 97 mg/L | 1 | 2005 |
Water hardness in towns near Prairie Ridge
| Town | Distance | Median | Class |
|---|---|---|---|
| Bonney Lake | 4 mi | 61 mg/L | Moderately hard |
| Lake Tapps | 6 mi | 61 mg/L | Moderately hard |
| South Hill | 7 mi | 64 mg/L | Moderately hard |
| Sumner | 7 mi | 76 mg/L | Moderately hard |
| Puyallup | 8 mi | 62 mg/L | Moderately hard |
| Enumclaw | 8 mi | 55 mg/L | Soft |
| Edgewood | 9 mi | 76 mg/L | Moderately hard |
| Graham | 10 mi | 59 mg/L | Soft |
| Frederickson | 11 mi | 52 mg/L | Soft |
| Lakeland South | 11 mi | 61 mg/L | Moderately hard |
Pierce County
Prairie Ridge is in Pierce County, where the median is 51 mg/L (soft) across 73 sites.
See all of Pierce County →Washington
The statewide median is 74 mg/L (moderately hard) from 890 sites.
Washington hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.