Water hardness in Puyallup, WA

Water in Puyallup is moderately hard, with a median of 62 mg/L (3.6 grains per gallon) across 22 monitoring sites within 10 miles.

16% softer than the Washington median (74 mg/L) 65th hardest of 122 Washington towns Population 42,179
62mg/L
3.6 grains per gallon
Moderately hard

Puyallup tap water at a glance

  • HardnessModerately hard (62 mg/L, 3.6 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFAS1 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
  • Lead pipesNo known lead lines; 2,681 lines are still of unknown material.Check your own pipe →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 62 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 3.6 gpg (3.5 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites22
Lab samples146
Sample years2000–2017
Middle 50% of sites50–93 mg/L
Groundwater (wells, springs)59 mg/L · 14 sites
Surface water (rivers, lakes)68 mg/L · 8 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Puyallup

Prefilled with Puyallup's measured local hardness of 62 mg/L (3.6 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Puyallup tap water

City of Puyallup is the main public water system for Puyallup. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 16 samples taken Dec 2023 – Sep 2024. 1 PFAS was detected.

ChemicalHighest resultDetected inEPA limit
PFBS
perfluorobutane sulfonic acid
4.4 ppt 2 of 16 samples —

Other water systems serving parts of Puyallup

Water systemPFAS detectedHighest PFOA / PFOSTested
Southwood Water System
serves over 10,000 people
PFPeA, PFHxA, PFBA +3 more 6.2 / 8.9 ppt Apr 2024 – Oct 2025
City of Tacoma Water Division
serves over 10,000 people
PFHxS, PFBS — Jan 2025 – Oct 2025
Firgrove Mutual INC
serves over 10,000 people
PFOS, PFBS, PFOA 4.4 / 8.6 ppt Jan 2023 – Jan 2024
Fruitland Mutual Water Company
serves over 10,000 people
PFBS, PFOA, PFPeA +1 more 4 / ND ppt Apr 2023 – Jan 2024
Summit Water & Supply
serves over 10,000 people
PFPeA — May 2023 – Nov 2023

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Puyallup

City of Puyallup reported 11,735 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 2,681 lines are still of unknown material.

0lead (0%)
0galvanized requiring replacement
2,681unknown material (23%)
9,054not lead (77%)

Other water systems serving parts of Puyallup

Water systemService linesTotal
Southwood0 lead · 0 galvanized · 10,270 unknown15,670
City of Tacoma Water Division0 lead · 0 galvanized · 0 unknown114,107
Firgrove Mutual INC0 lead · 0 galvanized · 0 unknown354
Fruitland Mutual Water Company0 lead · 0 galvanized · 1,057 unknown3,457
Summit Water & Supply0 lead · 0 galvanized · 0 unknown4,960

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Puyallup drinking water violations

EPA records show no health-based violations for City of Puyallup since 2016.

Other water systems serving parts of Puyallup

Water systemHealth-based violationsMonitoring/reporting
Southwood Water SystemNone4
City of Tacoma Water DivisionNone0
Firgrove Mutual INCNone0
Fruitland Mutual Water CompanyNone9
Summit Water & SupplyNone1

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Puyallup

SiteTypeDistanceMedianSamplesYears
PUYALLUP RIVER AT MERIDIAN ST
Washington Department Of Ecology
River/Stream 1.6 mi24 mg/L42011–2012
19N/04E-02F02 UR-34
USGS Washington Water Science Center
Well 1.7 mi33 mg/L12005
20N/04E-36P02 UR-35B
USGS Washington Water Science Center
Well 2.5 mi127 mg/L92000–2012
19N/04E-22A01 UR-29A
USGS Washington Water Science Center
Well 4 mi97 mg/L12005
19N/04E-23N01 UR-30
USGS Washington Water Science Center
Well 4.7 mi310 mg/L12005
HYLEBOS CREEK @ 8TH ST. E
Washington Department Of Ecology
River/Stream 5.6 mi93 mg/L62010–2011

Water hardness in towns near Puyallup

TownDistanceMedianClass
Edgewood4 mi 76 mg/LModerately hard
South Hill4 mi 64 mg/LModerately hard
Sumner4 mi 76 mg/LModerately hard
Fife5 mi 70 mg/LModerately hard
Bonney Lake6 mi 61 mg/LModerately hard
Lake Tapps7 mi 61 mg/LModerately hard
Lakeland South7 mi 61 mg/LModerately hard
Frederickson7 mi 52 mg/LSoft
Parkland7 mi 52 mg/LSoft
Prairie Ridge8 mi 54 mg/LSoft

Pierce County

Puyallup is in Pierce County, where the median is 51 mg/L (soft) across 73 sites.

See all of Pierce County →

Washington

The statewide median is 74 mg/L (moderately hard) from 890 sites.

Washington hardness map →

Puyallup, WA water: common questions

Do I need a water softener in Puyallup?

Probably not. Water measured around Puyallup is 3.6 gpg (62 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 7,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Puyallup's drinking water?

The main public water system serving Puyallup in EPA records is City of Puyallup. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Puyallup?

It depends on what you want to remove. In Puyallup, EPA testing found PFBS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next