Water hardness in Sanpete County, UT

Water in Sanpete County is very hard, with a median of 296 mg/L (17.3 grains per gallon) across 80 monitoring sites.

16% harder than the Utah median (256 mg/L) 10th hardest of 29 counties
296mg/L
17.3 grains per gallon
Very hard

Sanpete County water at a glance

  • HardnessVery hard (296 mg/L, 17.3 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 296 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 17.3 gpg (16.6 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites80
Lab samples850
Sample years2000–2021
Middle 50% of sites233–398 mg/L
Groundwater (wells, springs)320 mg/L · 24 sites
Surface water (rivers, lakes)247 mg/L · 56 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Sanpete County

Prefilled with Sanpete County's measured local hardness of 296 mg/L (17.3 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Sanpete County on the Utah map

Duchesne CountyCache CountySummit CountySan Juan CountyRich CountyWashington CountyIron CountyJuab CountyCarbon CountyEmery CountyGrand CountyTooele CountyWayne CountyUintah CountyGarfield CountyKane CountyBox Elder CountyMillard CountyWeber CountyWasatch CountyMorgan CountyDavis CountySalt Lake CountyBeaver CountyPiute CountyUtah CountySevier CountyDaggett County

Cities and communities in Sanpete County

PlaceMedian mg/LClassBased on
Ephraim 357 Very hard 27 sites within 10 miles
Mount Pleasant 310 Very hard 23 sites within 10 miles
Manti 304 Very hard 31 sites within 10 miles
Gunnison 435 Very hard 19 sites within 10 miles
Moroni 354 Very hard 21 sites within 10 miles
Centerfield 288 Very hard 20 sites within 10 miles
Fairview 240 Very hard 22 sites within 10 miles
Fountain Green 288 Very hard 14 sites within 10 miles
Spring City 360 Very hard 22 sites within 10 miles
Mayfield 267 Very hard 20 sites within 10 miles
Wales 354 Very hard 23 sites within 10 miles
Sterling 295 Very hard 25 sites within 10 miles
Fayette 464 Very hard 15 sites within 10 miles

Water quality in Sanpete County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Ephraim Ephraim City None detected 0 lead · 692 unknown None
Mount Pleasant Mount Pleasant City None detected 0 lead · 0 unknown 5
Manti Manti City None detected 0 lead · 0 unknown None
Gunnison Gunnison City None detected 0 lead · 347 unknown None
Moroni Moroni City Not tested 0 lead · 478 unknown None
Centerfield Centerfield Town Water System Not tested 0 lead · 116 unknown None
Fairview Fairview City Water System Not tested 0 lead · 353 unknown None
Fountain Green Fountain Green Not tested 0 lead · 0 unknown 1
Spring City Spring City Not tested 0 lead · 316 unknown 1
Mayfield Mayfield Town Water System Not tested 0 lead · 138 unknown None
Wales Wales Town Water System Not tested 0 lead · 0 unknown None
Sterling Sterling Town Water System Not tested 0 lead · 79 unknown 2
Fayette Fayette Town Not tested 0 lead · 0 unknown None

Neighboring counties

Utah

The statewide median is 256 mg/L (very hard) from 4,077 sites.

Utah hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next