Water hardness in Kane County, UT

Water in Kane County is very hard, with a median of 279 mg/L (16.3 grains per gallon) across 85 monitoring sites.

9% harder than the Utah median (256 mg/L) 12th hardest of 29 counties
279mg/L
16.3 grains per gallon
Very hard

Kane County water at a glance

  • HardnessVery hard (279 mg/L, 16.3 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 279 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 16.3 gpg (15.6 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites85
Lab samples2,752
Sample years2000–2021
Middle 50% of sites217–536 mg/L
Groundwater (wells, springs)248 mg/L · 22 sites
Surface water (rivers, lakes)293 mg/L · 63 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Kane County

Prefilled with Kane County's measured local hardness of 279 mg/L (16.3 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Kane County on the Utah map

Duchesne CountyCache CountySanpete CountySummit CountySan Juan CountyRich CountyWashington CountyIron CountyJuab CountyCarbon CountyEmery CountyGrand CountyTooele CountyWayne CountyUintah CountyGarfield CountyBox Elder CountyMillard CountyWeber CountyWasatch CountyMorgan CountyDavis CountySalt Lake CountyBeaver CountyPiute CountyUtah CountySevier CountyDaggett County

Cities and communities in Kane County

PlaceMedian mg/LClassBased on
Kanab 307 Very hard 15 sites within 10 miles
Orderville 279 Very hard 11 sites within 10 miles
Big Water 279 Very hard county median
Glendale 282 Very hard 8 sites within 10 miles
Alton 279 Very hard 5 sites within 10 miles

Water quality in Kane County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Kanab Kanab City None detected 0 lead · 0 unknown 1
Orderville Orderville Town Water System Not tested 0 lead · 0 unknown None
Glendale Glendale Town Water System Not tested 0 lead · 113 unknown 2
Alton Alton Town Water System Not tested 0 lead · 36 unknown 6

Neighboring counties

Utah

The statewide median is 256 mg/L (very hard) from 4,077 sites.

Utah hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next