Water hardness in Duchesne County, UT

Water in Duchesne County is very hard, with a median of 194 mg/L (11.3 grains per gallon) across 141 monitoring sites.

24% softer than the Utah median (256 mg/L) 25th hardest of 29 counties
194mg/L
11.3 grains per gallon
Very hard

Duchesne County water at a glance

  • HardnessVery hard (194 mg/L, 11.3 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 194 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 11.3 gpg (10.9 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites141
Lab samples1,844
Sample years2000–2021
Middle 50% of sites30–258 mg/L
Groundwater (wells, springs)172 mg/L · 25 sites
Surface water (rivers, lakes)209 mg/L · 116 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Duchesne County

Prefilled with Duchesne County's measured local hardness of 194 mg/L (11.3 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Duchesne County on the Utah map

Cache CountySanpete CountySummit CountySan Juan CountyRich CountyWashington CountyIron CountyJuab CountyCarbon CountyEmery CountyGrand CountyTooele CountyWayne CountyUintah CountyGarfield CountyKane CountyBox Elder CountyMillard CountyWeber CountyWasatch CountyMorgan CountyDavis CountySalt Lake CountyBeaver CountyPiute CountyUtah CountySevier CountyDaggett County

Cities and communities in Duchesne County

PlaceMedian mg/LClassBased on
Roosevelt 344 Very hard 24 sites within 10 miles
Duchesne 231 Very hard 31 sites within 10 miles
Myton 263 Very hard 16 sites within 10 miles
Neola (CDP) 174 Hard 27 sites within 10 miles
Bluebell (CDP) 170 Hard 18 sites within 10 miles
Altamont 152 Hard 15 sites within 10 miles
Tabiona 226 Very hard 11 sites within 10 miles

Water quality in Duchesne County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Roosevelt Roosevelt City Water System None detected 0 lead · 0 unknown 1
Duchesne Duchesne Water System Not tested 0 lead · 642 unknown None
Myton Myton City Not tested 0 lead · 215 unknown None
Neola Neola Water and Sewer District Not tested 0 lead · 193 unknown None
Tabiona Tabiona Town Water System Not tested 0 lead · 124 unknown 1

Neighboring counties

Utah

The statewide median is 256 mg/L (very hard) from 4,077 sites.

Utah hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next