Water hardness in Smith County, TX
Water in Smith County is soft, with a median of 47 mg/L (2.8 grains per gallon) across 14 monitoring sites.
Smith County water at a glance
- HardnessSoft (47 mg/L, 2.8 gpg, local measurements). A water softener isn't needed.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 47 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 2.8 gpg (2.6 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Smith County
Prefilled with Smith County's measured local hardness of 47 mg/L (2.7 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Smith County on the Texas map
Cities and communities in Smith County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Tyler | 62 | Moderately hard | 7 sites within 10 miles |
| Whitehouse | 64 | Moderately hard | 5 sites within 10 miles |
| Lindale | 62 | Moderately hard | 7 sites within 10 miles |
| Bullard | 47 | Soft | 9 sites within 10 miles |
| Hideaway | 62 | Moderately hard | 7 sites within 10 miles |
| Troup | 58 | Soft | 4 sites within 10 miles |
| Emerald Bay (CDP) | 47 | Soft | 11 sites within 10 miles |
| Arp | 38 | Soft | 3 sites within 10 miles |
| Noonday | 48 | Soft | 11 sites within 10 miles |
| Winona | 35 | Soft | 6 sites within 10 miles |
| New Chapel Hill | 47 | Soft | county median |
Water quality in Smith County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Tyler | City of Tyler | 2 found | 142 lead · 4,390 unknown | 4 |
| Whitehouse | City of Whitehouse | None detected | 0 lead · 2,573 unknown | 1 |
| Lindale | City of Lindale | None detected | 0 lead · 9 unknown | None |
| Bullard | City of Bullard | None detected | 0 lead · 0 unknown | 1 |
| Troup | City of Troup | Not tested | 0 lead · 131 unknown | None |
| Arp | City of ARP | Not tested | 0 lead · 0 unknown | 48 |
| Winona | City of Winona | Not tested | 0 lead · 48 unknown | 1 |
Neighboring counties
- Gregg County48 mg/L
- Wood County45 mg/L
- Upshur County38 mg/L
- Rusk County24 mg/L
- Van Zandt County47 mg/L
- Henderson County40 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.