Water hardness in Morris County, TX
Water in Morris County is moderately hard, with a median of 80 mg/L (4.6 grains per gallon) across 4 monitoring sites.
Morris County water at a glance
- HardnessModerately hard (80 mg/L, 4.6 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 80 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 4.6 gpg (4.5 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Morris County
Prefilled with Morris County's measured local hardness of 80 mg/L (4.7 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Morris County on the Texas map
Cities and communities in Morris County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Daingerfield | 95 | Moderately hard | 4 sites within 10 miles |
| Hughes Springs | 26 | Soft | 5 sites within 10 miles |
| Naples | 80 | Moderately hard | 4 sites within 10 miles |
| Lone Star | 38 | Soft | 7 sites within 10 miles |
| Omaha | 80 | Moderately hard | 3 sites within 10 miles |
Water quality in Morris County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Daingerfield | City of Daingerfield | 1 found | 5 lead · 1,030 unknown | None |
| Hughes Springs | City of Hughes Springs | 1 found | 0 lead · 0 unknown | 2 |
| Naples | City of Naples | Not tested | Not reported | 1 (1 open) |
| Lone Star | Lone Star Public Water System | Not tested | 0 lead · 0 unknown | None |
| Omaha | City of Omaha | Not tested | 2 lead · 257 unknown | None |
Neighboring counties
- Titus County104 mg/L
- Camp County38 mg/L
- Cass County26 mg/L
- Franklin County44 mg/L
- Bowie County73 mg/L
- Upshur County38 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.