Water hardness in Robertson County, TX
Water in Robertson County is moderately hard, with a median of 65 mg/L (3.8 grains per gallon) across 3 monitoring sites.
Robertson County water at a glance
- HardnessModerately hard (65 mg/L, 3.8 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 65 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 3.8 gpg (3.6 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Robertson County
Prefilled with Robertson County's measured local hardness of 65 mg/L (3.8 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Robertson County on the Texas map
Cities and communities in Robertson County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Hearne | 65 | Moderately hard | county median |
| Franklin | 65 | Moderately hard | county median |
| Calvert | 65 | Moderately hard | county median |
| Bremond | 65 | Moderately hard | county median |
Water quality in Robertson County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Hearne | City of Hearne | None detected | 0 lead · 1,793 unknown | None |
| Franklin | City of Franklin | Not tested | 0 lead · 0 unknown | None |
| Calvert | City of Calvert | None detected | 0 lead · 511 unknown | 1 |
| Bremond | City of Bremond | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Brazos County57 mg/L
- Milam County132 mg/L
- Madison County14 mg/L
- Leon County8 mg/L
- Limestone County89 mg/L
- Burleson County8 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.