Water hardness in Tripp County, SD

Water in Tripp County is very hard, with a median of 180 mg/L (10.5 grains per gallon) across 1 monitoring site.

56% softer than the South Dakota median (410 mg/L) 51st hardest of 54 counties
180mg/L
10.5 grains per gallon
Very hard

Tripp County water at a glance

  • HardnessVery hard (180 mg/L, 10.5 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 180 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 10.5 gpg (10.1 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites1
Lab samples32
Sample years2000–2014
Middle 50% of sites180–180 mg/L
Surface water (rivers, lakes)180 mg/L · 1 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Tripp County

Prefilled with Tripp County's measured local hardness of 180 mg/L (10.5 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Tripp County on the South Dakota map

Moody CountyAurora CountyDavison CountyTurner CountyDay CountyFall River CountyBrule CountyMcCook CountyMiner CountyGrant CountyBrown CountyBeadle CountyBrookings CountyClark CountySpink CountyHamlin CountyKingsbury CountyBuffalo CountyEdmunds CountyJerauld CountyHyde CountyDouglas CountySanborn CountyDeuel CountyHutchinson CountyHand CountyLyman CountySully CountyPotter CountyLake CountyHarding CountyHanson CountyUnion CountyCorson CountyYankton CountyGregory CountyCharles Mix CountyMarshall CountyClay CountyLawrence CountyHaakon CountyBon Homme CountyPennington CountyMinnehaha CountyDewey CountyCuster CountyMellette CountyMeade CountyFaulk CountyWalworth CountyTodd CountyButte CountyBennett CountyCodington CountyHughes CountyStanley CountyZiebach CountyRoberts CountyMcPherson CountyLincoln CountyJones CountyOglala Lakota CountyPerkins CountyJackson CountyCampbell County

Cities and communities in Tripp County

PlaceMedian mg/LClassBased on
Winner 180 Very hard county median
Colome 180 Very hard county median
New Witten 180 Very hard county median
Hamill (CDP) 180 Very hard county median
Ideal (CDP) 180 Very hard county median

Water quality in Tripp County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Winner Winner Not tested 0 lead · 1,684 unknown None
Colome Colome Not tested 0 lead · 192 unknown 2
Hamill Tripp County Water User District None detected 0 lead · 1,366 unknown None

Neighboring counties

South Dakota

The statewide median is 410 mg/L (very hard) from 498 sites.

South Dakota hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next