Water hardness in Williamsburg County, SC

Water in Williamsburg County is soft, with a median of 21 mg/L (1.2 grains per gallon) across 19 monitoring sites.

about the same as the South Carolina median (18 mg/L) 24th hardest of 46 counties
21mg/L
1.2 grains per gallon
Soft

Williamsburg County water at a glance

  • HardnessSoft (21 mg/L, 1.2 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 21 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 1.2 gpg (1.2 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites19
Lab samples163
Sample years2000–2026
Middle 50% of sites19–26 mg/L
Groundwater (wells, springs)8 mg/L · 3 sites
Surface water (rivers, lakes)22 mg/L · 16 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Williamsburg County

Prefilled with Williamsburg County's measured local hardness of 21 mg/L (1.2 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Williamsburg County on the South Carolina map

Saluda CountyBamberg CountyFlorence CountyLaurens CountyLee CountyBeaufort CountyCharleston CountyDorchester CountyChester CountyDillon CountyLexington CountyPickens CountyNewberry CountySumter CountyAbbeville CountyAiken CountyAllendale CountyAnderson CountyBarnwell CountyEdgefield CountyFairfield CountyHampton CountyHorry CountyMcCormick CountyGreenwood CountyCalhoun CountyMarion CountyChesterfield CountyYork CountyGreenville CountyKershaw CountyOconee CountyGeorgetown CountyDarlington CountyOrangeburg CountyColleton CountyMarlboro CountyRichland CountyLancaster CountyJasper CountyClarendon CountyCherokee CountyBerkeley CountyUnion CountySpartanburg County

Cities and communities in Williamsburg County

PlaceMedian mg/LClassBased on
Kingstree 19 Soft 11 sites within 10 miles
Andrews 21 Soft county median
Hemingway 21 Soft 10 sites within 10 miles
Lane 19 Soft 13 sites within 10 miles
Greeleyville 20 Soft 8 sites within 10 miles
Stuckey 22 Soft 8 sites within 10 miles

Water quality in Williamsburg County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Kingstree Town of Kingstree None detected 0 lead · 2,252 unknown None
Andrews Town of Andrews None detected 0 lead · 5 unknown None
Hemingway Town of Hemingway None detected 0 lead · 569 unknown 7
Lane Lane Town of (4510005) Not tested 0 lead · 50 unknown None
Greeleyville Town of Greeleyville Not tested 5 lead · 106 unknown None
Stuckey Town of Stuckey Not tested 0 lead · 159 unknown None

Neighboring counties

South Carolina

The statewide median is 18 mg/L (soft) from 2,209 sites.

South Carolina hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next