Water hardness in Bradford County, PA
Water in Bradford County is moderately hard, with a median of 89 mg/L (5.2 grains per gallon) across 162 monitoring sites.
Bradford County water at a glance
- HardnessModerately hard (89 mg/L, 5.2 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 89 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 5.2 gpg (5 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Bradford County
Prefilled with Bradford County's measured local hardness of 89 mg/L (5.2 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Bradford County on the Pennsylvania map
Cities and communities in Bradford County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Sayre | 119 | Moderately hard | 19 sites within 10 miles |
| Athens | 120 | Moderately hard | 24 sites within 10 miles |
| Towanda | 115 | Moderately hard | 43 sites within 10 miles |
| Canton | 43 | Soft | 30 sites within 10 miles |
| Troy | 85 | Moderately hard | 50 sites within 10 miles |
| South Waverly | 112 | Moderately hard | 17 sites within 10 miles |
| Greens Landing (CDP) | 120 | Moderately hard | 22 sites within 10 miles |
| Wyalusing | 109 | Moderately hard | 30 sites within 10 miles |
| Monroe | 105 | Moderately hard | 48 sites within 10 miles |
| Rome | 82 | Moderately hard | 48 sites within 10 miles |
| LeRaysville | 36 | Soft | 28 sites within 10 miles |
| New Albany | 78 | Moderately hard | 30 sites within 10 miles |
| Sylvania | 127 | Hard | 23 sites within 10 miles |
| Burlington | 84 | Moderately hard | 66 sites within 10 miles |
| Alba | 117 | Moderately hard | 25 sites within 10 miles |
| East Smithfield (CDP) | 84 | Moderately hard | 60 sites within 10 miles |
| North Towanda (CDP) | 115 | Moderately hard | 44 sites within 10 miles |
| Ulster (CDP) | 82 | Moderately hard | 73 sites within 10 miles |
Water quality in Bradford County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Towanda | Towanda Municipal Authority | None detected | 0 lead · 1,952 unknown | 2 |
| Canton | Canton Borough Authority | Not tested | 0 lead · 161 unknown | None |
| Wyalusing | Wyalusing Municipal Authority | Not tested | 0 lead · 295 unknown | None |
| Ulster | Ulster Municipal Authority | Not tested | 0 lead · 157 unknown | 1 |
Neighboring counties
- Sullivan County38 mg/L
- Wyoming County75 mg/L
- Susquehanna County63 mg/L
- Tioga County55 mg/L
- Lycoming County40 mg/L
- Luzerne County36 mg/L
Pennsylvania
The statewide median is 82 mg/L (moderately hard) from 4,757 sites.
Pennsylvania hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.