Water hardness in Maryland Heights, MO

Water in Maryland Heights is very hard, with a median of 292 mg/L (17.1 grains per gallon) across 34 monitoring sites within 10 miles.

40% harder than the Missouri median (209 mg/L) 18th hardest of 87 Missouri towns Population 27,575
292mg/L
17.1 grains per gallon
Very hard

Maryland Heights tap water at a glance

  • HardnessVery hard (292 mg/L, 17.1 gpg, local measurements). Water softeners are common at this level.Size a water softener →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 292 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 17.1 gpg (16.4 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites34
Lab samples515
Sample years2000–2026
Middle 50% of sites235–359 mg/L
Groundwater (wells, springs)394 mg/L · 9 sites
Surface water (rivers, lakes)264 mg/L · 25 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Maryland Heights

Prefilled with Maryland Heights's measured local hardness of 292 mg/L (17.1 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Maryland Heights tap water

Maryland Heights is served by more than one water system. These systems supply ZIP codes in Maryland Heights and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Maryland Heights

Water systemPFAS detectedHighest PFOA / PFOSTested
Mo American ST Louis ST Charles Counties
serves over 10,000 people
PFBA — Mar 2024 – Dec 2024
ST Louis City PWS
serves over 10,000 people
None detected — Mar 2024 – Dec 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Maryland Heights

Maryland Heights is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Maryland Heights

Water systemService linesTotal
Mo American ST Louis ST Charles Counties9,422 lead · 1,247 galvanized · 191,341 unknown388,276
ST Louis City PWS9,990 lead · 525 galvanized · 64,378 unknown105,873

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Maryland Heights drinking water violations

Maryland Heights is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Maryland Heights

Water systemHealth-based violationsMonitoring/reporting
Mo American ST Louis ST Charles CountiesNone0
ST Louis City PWSNone8

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Maryland Heights

SiteTypeDistanceMedianSamplesYears
WLL-USGS-D1
USGS Missouri Water Science Center
Well 0.5 mi536 mg/L12013
WLL-USGS-B3
USGS Missouri Water Science Center
Well 0.8 mi352 mg/L12013
WLL-USGS-B4-S
USGS Missouri Water Science Center
Well 1.4 mi416 mg/L12013
Fee Fee Creek near Bridgeton, MO
USGS Missouri Water Science Center
Stream 1.5 mi276 mg/L292000–2004
Creve Coeur Creek near Creve Coeur, MO
USGS Missouri Water Science Center
Stream 2.5 mi264 mg/L512000–2007
Creve Coeur Cr.@Hwy 340
Midwest Envir. Consultants
River/Stream 2.5 mi250 mg/L192010–2011

Water hardness in towns near Maryland Heights

TownDistanceMedianClass
Creve Coeur4 mi 266 mg/LVery hard
St. Ann5 mi 294 mg/LVery hard
Bridgeton5 mi 320 mg/LVery hard
Overland6 mi 294 mg/LVery hard
St. Charles6 mi 322 mg/LVery hard
Town and Country6 mi 274 mg/LVery hard
Hazelwood7 mi 312 mg/LVery hard
Chesterfield7 mi 262 mg/LVery hard
University City8 mi 266 mg/LVery hard
St. Peters8 mi 270 mg/LVery hard

St. Louis County

Maryland Heights is in St. Louis County, where the median is 261 mg/L (very hard) across 61 sites.

See all of St. Louis County →

Missouri

The statewide median is 209 mg/L (very hard) from 1,834 sites.

Missouri hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next