Water hardness in Owings Mills, MD

Water in Owings Mills is moderately hard, with a median of 76 mg/L (4.4 grains per gallon) across 54 monitoring sites within 10 miles.

36% harder than the Maryland median (56 mg/L) 64th hardest of 121 Maryland towns Population 30,622 (2010)
76mg/L
4.4 grains per gallon
Moderately hard

Owings Mills tap water at a glance

  • HardnessModerately hard (76 mg/L, 4.4 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 76 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 4.4 gpg (4.3 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites54
Lab samples127
Sample years2000–2019
Middle 50% of sites60–133 mg/L
Groundwater (wells, springs)82 mg/L · 44 sites
Surface water (rivers, lakes)64 mg/L · 10 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Owings Mills

Prefilled with Owings Mills's measured local hardness of 76 mg/L (4.4 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Owings Mills tap water

Owings Mills is served by more than one water system. These systems supply ZIP codes in Owings Mills and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Owings Mills

Water systemPFAS detectedHighest PFOA / PFOSTested
City of Baltimore
serves over 10,000 people
PFPeA — Aug 2024 – May 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Owings Mills

Owings Mills is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Owings Mills

Water systemService linesTotal
City of Baltimore47 lead · 385 galvanized · 335,694 unknown336,126

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Owings Mills drinking water violations

Owings Mills is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Owings Mills

Water systemHealth-based violationsMonitoring/reporting
City of Baltimore47

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Owings Mills

SiteTypeDistanceMedianSamplesYears
RED RUN NEAR BELLTOWN, MD
USGS Maryland Water Science Center
Stream 1.2 mi78 mg/L12000
GWYNNS FALLS TRIBUTARY AT MCDONOGH, MD
USGS Maryland Water Science Center
Stream 1.2 mi46 mg/L12000
BA Dc 454
USGS Maryland Water Science Center
Well 3.1 mi67 mg/L12000
BA Ec 205
USGS Maryland Water Science Center
Well 3.3 mi237 mg/L12001
BA Dc 455
USGS Maryland Water Science Center
Well 3.4 mi138 mg/L12000
BA Dc 456
USGS Maryland Water Science Center
Well 3.4 mi137 mg/L12000

Water hardness in towns near Owings Mills

TownDistanceMedianClass
Randallstown3 mi 70 mg/LModerately hard
Reisterstown3 mi 78 mg/LModerately hard
Milford Mill4 mi 78 mg/LModerately hard
Pikesville5 mi 237 mg/LVery hard
Lochearn5 mi 138 mg/LHard
Mays Chapel7 mi 216 mg/LVery hard
Woodlawn8 mi 103 mg/LModerately hard
Eldersburg9 mi 61 mg/LModerately hard
Towson9 mi 244 mg/LVery hard
Ellicott City10 mi 76 mg/LModerately hard

Baltimore County

Owings Mills is in Baltimore County, where the median is 154 mg/L (hard) across 198 sites.

See all of Baltimore County →

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next