Water hardness in Hillcrest Heights, MD

Water in Hillcrest Heights is moderately hard, with a median of 77 mg/L (4.5 grains per gallon) across 11 monitoring sites within 10 miles.

38% harder than the Maryland median (56 mg/L) 60th hardest of 121 Maryland towns Population 16,469 (2010)
77mg/L
4.5 grains per gallon
Moderately hard

Hillcrest Heights tap water at a glance

  • HardnessModerately hard (77 mg/L, 4.5 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 77 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 4.5 gpg (4.3 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites11
Lab samples12
Sample years2000–2016
Middle 50% of sites57–122 mg/L
Groundwater (wells, springs)128 mg/L · 3 sites
Surface water (rivers, lakes)60 mg/L · 8 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Hillcrest Heights

Prefilled with Hillcrest Heights's measured local hardness of 77 mg/L (4.5 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Hillcrest Heights tap water

Hillcrest Heights is served by more than one water system. These systems supply ZIP codes in Hillcrest Heights and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Hillcrest Heights

Water systemPFAS detectedHighest PFOA / PFOSTested
Washington Suburban Sanitary Commission
serves over 10,000 people
PFPeA, PFHxA — Mar 2023 – Jun 2024
MGM National Harbor
serves over 10,000 people
PFBA — Mar 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Hillcrest Heights

Hillcrest Heights is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Hillcrest Heights

Water systemService linesTotal
Washington Suburban Sanitary Commission8 lead · 1,277 galvanized · 57,121 unknown58,406
MGM National Harbor0 lead · 0 galvanized · 0 unknown0

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Hillcrest Heights drinking water violations

Hillcrest Heights is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Hillcrest Heights

Water systemHealth-based violationsMonitoring/reporting
Washington Suburban Sanitary CommissionNone0
MGM National Harbor11

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Hillcrest Heights

SiteTypeDistanceMedianSamplesYears
UNNAMED TRIB TO HENSON CREEK AT SUITLAND, MD
USGS Maryland Water Science Center
Stream 2.9 mi77 mg/L12000
PAYNES BRANCH AT CLINTON, MD
USGS Maryland Water Science Center
Stream 4.9 mi53 mg/L12000
HUNTERS MILL BRANCH TRIBUTARY NEAR FRIENDLY, MD
USGS Maryland Water Science Center
Stream 5.3 mi46 mg/L12000
PEA HILL BRANCH AT CAMP SPRINGS, MD
USGS Maryland Water Science Center
Stream 5.6 mi52 mg/L12000
PG Ed 60
USGS Maryland Water Science Center
Well 6.2 mi128 mg/L22010–2016
PG Ed 50
USGS Maryland Water Science Center
Well 6.3 mi123 mg/L12016

Water hardness in towns near Hillcrest Heights

TownDistanceMedianClass
Glassmanor1 mi 77 mg/LModerately hard
Suitland3 mi 77 mg/LModerately hard
Oxon Hill3 mi 52 mg/LSoft
Camp Springs4 mi 68 mg/LModerately hard
Walker Mill5 mi 67 mg/LModerately hard
Forestville5 mi 77 mg/LModerately hard
Clinton7 mi 56 mg/LSoft
Summerfield7 mi 67 mg/LModerately hard
Fort Washington8 mi 52 mg/LSoft
Landover8 mi 60 mg/LModerately hard

Prince George's County

Hillcrest Heights is in Prince George's County, where the median is 60 mg/L (moderately hard) across 27 sites.

See all of Prince George's County →

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next